0
What else can I help you with?
Why is it that my ceiling fan works perfectly fine, but the light attached to it does not turn on?
The issue with your ceiling fan's light not turning on could be due to a problem with the light bulb, the light switch, or the wiring connecting the light to the fan. It is possible that the light bulb needs to be replaced, the light switch is faulty, or there is a wiring issue that needs to be addressed.
If the battery light keeps coming on and the alternator has been replaced what else could be the problem on 97 Mitsubishi eclipse?
it could mean that you have a loose battery cable that needs to be tightened
Your Car blinker does not go on anymore but all the light bulbs work what could be the problem?
Most likely turn signal flasher needs to be replaced
Why would the brake lights on your 95 ls turn on while the car is off and kill your battery?
Sounds like Stop light switch needs to be replaced Sounds like Stop light switch needs to be replaced
What does it mean when the console light flashes on a Mitsubishi grandis?
When a console light flashes on a Mitsubishi?æand the light continues to flash that may mean a sensor needs to be replaced. A certified mechanic can have it replaced.
Why is coolant leaking from the engine on a 1994 Chrysler new yorker?
It could be a head gasket that needs replaced or a freeze plug needs replaced depending where the leak is coming from. It could also be a radiator hose.
How do you take apart the back taillight of a 1989 Celebrity?
The entire taillight comes off as an assembly, and is not designed to be taken apart. To change a light bulb: 1. Inside the trunk look on the back side of the taillight near the quarter panel. There will be 3 nuts, the center nut holds the taillight assembly in place, remove that nut. 2. Pull the assembly rearward enough to bring the stud out from the header panel, then pull the tab out of the license plate light assembly. 3. Remove the socket that needs a new bulb and replace the bulb, then slide the taillight assembly back in place and put the nut back on.
How do you remove the tail light assembly after removing the 2 bolts of a 2004 Toyota Sienna LE?
There is a pin in the taillight that needs to be pulled straight to the side. Do not leverage it or the taillight might crack. My 2002 Sienna has 2 pins. By pulling the taillight assembly straight out sideways (perpendicular to the side the car), with a little gentle leverage from above and below, it popped out nicely. Be careful and gentle.
Your signal lights are not working on your 1994 Pontiac gran am?
When the signal lights are not working on a car, there are a couple of things that could be going on. One could be that the bulb needs to be replaced. The other possibility is that the signal relay needs to be replaced.
What is something in yourhouse that needs to be replaced regularly?
light bulb toilet tissue batteries groceries
What is something in your house that needs to be replaced regularly?
light bulbs toilet paper groceries batteries
Why do my water heater gas controls not move anymore?
It can be something as simple as that they are broken and needs to be replaced. Or the internal spring holding it could have worn out as well and also needs to be replaced.
