To disable the seat belt minder in a Kia Optima, turn on the ignition without starting the engine. Buckle and unbuckle the driver's seat belt 20 times within 30 seconds. After the 20th time, the seat belt reminder should chime, indicating that the feature is disabled. Always refer to your owner's manual for specific instructions related to your model year, as procedures may vary.
To disable the seat belt minder in a 2011 Kia Optima, start by turning the ignition to the "On" position without starting the engine. Then, buckle and unbuckle the driver's seat belt three times within 30 seconds. After the third time, the seat belt warning chime should turn off, indicating that the minder is disabled. Remember that this feature may need to be reactivated if the vehicle's battery is disconnected.
To disable the seat belt alarm on a 2011 Kia Optima, you can follow these steps: Sit in the driver's seat and buckle the seat belt; then turn the ignition key to the "On" position without starting the engine. Unbuckle and buckle the seat belt three times within 10 seconds. If done correctly, you should hear a chime indicating that the alarm has been disabled. However, it's important to note that disabling the seat belt alarm may compromise safety, so it's recommended to use the seat belt as intended.
You Can't. It is wired through the ignition system, Disable it car won't run. Safer to wear seatbelt. Wrong. All Ford products can have the Belt Minder disabled. Here is how you do it on the Mariner: Turn the ignition switch to on. Wait approximately 70 seconds for the seat belt light on the dash cluster to go out. For the seat belt you want to disable the minder on, insert and remove the belt approximately 10 times, you'll want to do it until you see the seat belt light turn on again. Then unbuckle the belt and the light will flash 4 times per second for a few seconds to confirm. This also works on F-150 pickups I know for sure, I just did it to confirm.
Wear the seat Belt !
Put on your seat belt.
To disable the seat belt alarm on a Chevy Colorado, locate the alarm fuse. Pull out the fuse to disable the alarm.
Buckle the seat belt around the back of the seat
1st- seat down 2nd- buckle seat belt.
Buckle up your seat belt and the chime will go off.
Use the seat belt and buckle up.
Found the procedure to "Deactivate" the Seat Belt Minder, On pages 135-136 of the On-line Owners Manual. Here's the URL https://myford.fordvehicles.com/
connect the 2 active wires at the seat belt receptal, (the thing you plug the seat belt into!!! )