0
Add your answer:
Earn +20 pts
How do you replace the light cover front on a 1998 Honda Accord LX?
The bumper has to come off! First remove the blinker lenses to access two bolts on either side, then in the engine compartment there are nuts on studs that have to be removed. (this proceedure is for taking headlight off car)
What is the Bolt pattern 2004 Honda Accord?
It is 5 studs at a 114.3 mm spacing, commonly called 5 x114.3.
How do you replace left front wheel studs on my 2002 suzuki xl7?
Pound your 2002 Suzuki left front wheel studs out. You will need to pound in the new studs in the same manner that you removed the old studs.
How do you replace wheel studs on a 2000 Honda civic?
To remove wheel studs from a 2000 Honda Civic the wheel needs to be removed. Taking the wheel hub completely off the vehicle makes the process of removing the studs easier. The studs are pressed in and use of a machine press to remove them is recommended.
How do you Replace front wheel studs on 2000 Montana?
You replace the wheel bearing hub assembly - it has studs, bearings and wheel speed sensor around $100 part
How do you replace wheel studs on a 95 Chevy s-10?
I belive they are the knock out type take off wheel and drum heat studs on the back hit from front. to replace put new studs in and put back on tires.
Lug nut torque for a 94 accord wagon?
The lug nut torque for a 1994 Honda Accord Wagon is approximately 80 ft pounds. It is important not to over tighten as the studs may break if mishandled.
How do you replace front wheel studs on 1962 pontiac catalina?
Remove the brake drum, drive out he damaged studs from the front of the drum, press in the new ones from the back of the drum, reinstall the drum.
How do you replace a front wheel lug stud on a 1995 Geo Tracker?
You need to get the rotor off to replace studs with new ones.
1994 Honda accord with 17 inch rims but when you put them on it bent the wheel studs a little bit you were wondering is it still safe to drive and take it on the innerstate and will they be safe?
Bent wheel studs!! No it is not safe to drive. Now way would I drive this vehicle until I replaced the bent studs.
How do you take out the wheel studs on the front end of a 1988 Honda Prelude?
Most of them just drive out. Get the new ones and you will see how they install.
How do you replace wheel studs on a sebring?
You have to remove the caliper and then the rotor and tap on the front of the stud with a hammer so that it slides out from the back.
