0
Im in the process of doing this right now. Alot more than i had anticipated.
The toughest thing you will come up against is removing the crankshaft pulley bolt. It is a 24mm. I tried everything possible for over 5 hours before resorting to the "starter" method. I broke 1 breaker bar, shattered 1 6pt socket, bent a 4 ft long torque bar... The bolt is a standard regular threaded bolt. Righty tighty..lefty loosy!! I used a breaker bar with a cut off handle (via my grinder) which left about 13+ inches. Put the 24mm air wrench socket on the bolt head with a 4 inch extension stickin out. Then attach the 13" breaker bar and set it at around 10 Oclock from the front of the engine... The engine turns clockwise when the starter is engaged. When you crank the starter the bar will turn about 110 degrees and "smack" into the frame that sits below the radiator. The sound is horrific! But, it actually worked on the third attempt. I tried every way possible to avoid doing it this way cause it just sounded so stupid. But it worked! So i have to recommend it. The factory manual method will just keep turning the engine over even when youre in 5th with the ebrake on and blocks on each wheel.
What else can I help you with?
What is the firing order for a 1986 Isuzu Trooper?
123456
Where is the temperature sending unit on a 1986 Isuzu trooper?
Check this Isuzu site: http://www.myisuzuparts.com/
What vehicles will a 1986 Isuzu trooper II 4 cylinder motor fit into?
getting ready to put the motor from my 1989 Trooper into a 1986 Trooper II... will let you know how it goes!
What is the spark plug gap for a 1986 Isuzu Trooper?
Plug gap is .040"
Where can you find an engine control module for a 1986 Isuzu trooper?
its under the center console between the seats
Where is the fuel filter on the 1986 Isuzu trooper located?
above right rear tire, no tools required 2 minute replacement
Will a 1986 Isuzu trooper door fit with a 1990 Isuzu trooper?
It may. depending on if the vehicles are 2 door or 4 door. if they are both 4-door models it should be totally fine. if the 86 is a 2 door I'm not sure. double check with measurements. NO, Different body lines, 2 and 4 door
Where is the oil dipstick in 1986 Isuzu trooper?
Oil dipstick and tranny dipstick tigether on rear of engine, next to firewall, on drivers' side of vehicle.
How do you replace timing belt in 1986 Pontiac sunburst?
Sunburst?
Picture of 1986 Isuzu Trooper 2 engine?
Type your answe[IMG]http://i340.photobucket.com/albums/o354/AudacityX/1229091114a.jpg[/IMG]r here...
Where is the fuel pump located on a 1986 Isuzu Trooper 2?
THE FUEL PUMP ON THE 1986 ISUZU TROOPER 2 GAS 2.3 ENGINE IS LOCATED UNDER THE INTAKE MANIFOLD. YOU CAN GET TO IN BY TAKING OFF THE FRONT PASSENGER WHEEL AND RUBBER GARD AND YOU WILL SEE IT. I HAVE ONE OF THESE TROOPERS. HOPE THIS HELPS.
Where is map sensor 1986 Isuzu pup 2.3L?
how much is corperator for a 1986 isuzu pup 2.3l
