How do you remove rear brake drum from a 1993 Toyota pickup?
You'll only find it in manual for that vehicle.
I am working on my 1994 Ext Cab Toyota Pickup and it has drum brakes.
On the 4WD SR5 truck, front brakes are disc, and rear brakes are drum.
if your van has rear drum brakes, adjust them up until there is a slight drag on the brakes. this usually does the trick to tighten up the parking brake.
To remove the drum from a 2WD Toyota pickup, you typically need 12mm bolts, commonly referred to as M12 bolts, for the brake drum assembly. However, it's essential to check your specific model year, as bolt sizes can vary slightly. Additionally, having the correct tools, like a socket wrench, will make the process easier. Always refer to your vehicle's service manual for precise specifications.
To adjust the brake on a Toyota Tercel, first, locate the brake adjustment mechanism, typically found at the rear brakes if you have drum brakes. If your Tercel has disc brakes, ensure the calipers are properly aligned. For drum brakes, turn the adjusting wheel or lever to either tighten or loosen the brake shoes until they are just touching the drum. After adjusting, pump the brake pedal a few times to ensure proper function before testing the vehicle.
If you have rear drum brakes, you have to adjust your rear brake shoes. That will also give you a better pedal and more stopping power.
To replace the rear brakes on a 1993 Toyota pickup, start by lifting the vehicle and securely supporting it with jack stands. Remove the rear wheels and then the brake drum by pulling it off; if it's stuck, gently tap it with a hammer. Replace the brake shoes by removing the retaining springs and hardware, then install the new shoes in the same configuration, ensuring everything is secured. Finally, reassemble the drum and wheel, and repeat for the other side before lowering the vehicle.
on the back behind the wheel hub should be a gear looking thing that moves turn it slowly until fully ajusted
There should be two screws on the face of the brake drum, remove those, and make sure the ebrake is off, then use a hammer to tap them off from the backside. Make sure u dont dent the backing plate.
Parts should be available at Auto Zone or Napa Auto parts