answersLogoWhite

0

Tha transfer case has a shift sheet, not the transmission. The transmission has a bushing and shift bolt. The bushing is usually rotted and the bolt mos likely sheared in half. When you pull out the shift level, be careful not to let the broken bolt tip fall into the tranny.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Does the suzuki sidekick and samurai take the same shifter bushings?

no


Is there a spring under the cap of the shifter holding the shifter in place on the transfer case on the suzuki samurai?

Yes, a spring is located there. Download the FREE Suzuki Samurai Shop Manual from http://www.suzukiinfo.com/ or visit zukikrawlers.com zn


How do you change a Suzuki samurai transmission?

To change a Suzuki Samurai transmission, first, ensure the vehicle is on a level surface and securely lifted. Disconnect the battery, then remove the drive shafts, transfer case, and any electrical connections. Next, unbolt the transmission from the engine and carefully lower it using a transmission jack. Finally, install the new transmission by reversing the removal process, ensuring all connections are secure before testing.


What size bolt is used in a Suzuki Samurai transmission?

14 mm


Why is your suzuki samurai transmission stuck in gear?

the pin is broke inside the shifter case. put it in neutral, if possible, and unbolt the 4 bolts holding the case in place. it should take a 12mm. once you remove the shifter, the little pin inside the shifter case should be wiggly. just replace it. i did it when i was 12


What is the correct transmission fluid to use in a 87' suzuki samurai?

80w90 gear oil


Why wont your suzuki samurai go into 2 hi?

the shifter sheet needs replaced this can be done without removing the transfer case


Why does your suzuki samurai not stay in 4wd low?

It needs a new 'Shifter Sheet' Easy to put in and not too expensive. It is available on Ebay.


What is the gear ratio for first gear in a suzuki samurai transmission?

'86 Samurai 5 speed transmission 1st gear final reduction ratio from the factory manual is: 3.652


Will a 1987 transmission from a suzuki samurai work in a 1988 samurai?

87 trans will fit 88 but not to sure about 88 1/2 and later models


Why speedometer will not work on a Suzuki swift?

ck transmission gear selector on transmission. follow cable from shifter to (usually) top of trans. it is electronic


Where can you find an exploded view of a 1988 suzuki samurai 5 speed transmission?

Download the FREE Suzuki Samurai Shop Manual from http://www.suzukiinfo.com/. Complete drawings and photos of all components of the Samurai as well as rebuild information is contained therein. zn