To check the transfer case oil on a 1997 GMC Jimmy, first ensure the vehicle is parked on a level surface and is in neutral. Locate the transfer case, which is typically mounted to the rear of the transmission. Remove the fill plug on the side of the transfer case using a wrench; the oil level should be just below the fill hole. If oil seeps out when the plug is removed, the level is adequate; if not, you may need to add the appropriate type of fluid until it reaches the correct level.
The encoder motor is located on the transfer case. The transfer case is on the driver's side of the truck. It resides between the front drive line, and the wall of the transfer case.
how do you check the oil for the front transfer case on a 1990 Toyota four runner
the transmission and transfer case must removed from back of engine to access rear main seal.
it goes into tranny behind transfer case
Motorcraft MERCON automatic transmission fluid in the transfer case , according to the Owner Guide
Motorcraft MERCON automatic transmission fluid ( 2.64 pints / 1.25 liters ) is used in the transfer case of a 1997 Mercury Mountaineer
Fill plug is located on the center rear of the transfer case.Fill plug is located on the center rear of the transfer case.
check metal tag on transfer. for info.
chances are there is something loose in the transfer case. If you check and find out that is true then you may need to get a new transfer case.
Check the transfer case. If it is overfull, the rear trans seal has failed.
On a 1997 Ford Explorer 4x4 : The transfer case is bolted to the rear of the transmission underneath the vehicle
The vacuum switch is on the top of the transfer case. The 4wd indicator switch is on the front axle shift actuator.