pull the dash apart. behind the speedometer you will see the cable. it connects to the transmission.
no 280zx,its 153624
yes
To replace the starter on an 1983 280ZX, first disconnect the negative battery terminal to ensure safety. Then, remove any components obstructing access to the starter, such as the air intake or exhaust heat shield. Unbolt the starter from its mounting location, disconnect the wiring harness, and then replace it with the new starter by reversing the removal steps. Finally, reconnect the battery and test the new starter to ensure it functions properly.
I have the same problem. Did you resove it? I suspect it is a charging issue. Maybe a poor connection somewhere.
9tCarefully disconnect the speedo cable under the dash where it come thru the firewall and see if the end that is connected to the back of the speedo is abnormally loose. Mine was and caused a similar problem, I tightened it and problem went away for almost a year but it came loose again so I just replaced the speedo. Just as a side note, if you had any tranny work it could be an incorrect speedometer gear in the transmission if you replaced the trans that is.
have a lift handy to lift the car. disconnect the driveshaft. then the axles, wires, sensors etc. unbolt everything then pull it out. u will probably want to drain the dif 1st
My 82 280zx turbo shows 650rpm on the decal under the hood...
13,990
What is the process for installing a new timing chain for a 1980 datsun 280zx?
overhead cams with 280zx fit 280 z tops?
2.8 lieter