To fix the inside trunk latch cable on a 2000 Toyota Echo, first, locate the latch mechanism inside the trunk and inspect the cable for any breaks or disconnections. If the cable is detached, reattach it to the latch mechanism securely. If the cable is damaged, you may need to replace it; remove the old cable by detaching it from the latch and routing a new one in the same path. Finally, test the latch to ensure it operates smoothly before reassembling any trim or panels.
Yes.
On the inside of the trunk lid there is a little plastic black box that attaches to the release mechanism on the bottom of the trunk lid (where the lid meets the latch). On one side of this black box, there is a cable running out that runs up to the key. On the other side, you can either attach an auto trunk pop solenoid, or a release cable that runs inside your car to a handle. There is a rectangular cover on the black box that you will need to pry up with a screwdriver. Pry this lid open, and you will see a little orange thing in there. Take your cable and place it inside of this orange "hook". The cable has a ball on the end of it, and the ball on the cable needs to sit inside of the orange "hook". Then, make sure the cable is properly seated inside of the little black box, and push the cover closed. Make sure the cover snaps all the way around, or the cable might fall out again.
To replace the engine compartment release cable on a 2000 MR2 Spyder, first, open the trunk and locate the cable's attachment point near the latch. Disconnect the old cable by removing any clips or fasteners securing it in place. Then, route the new cable through the same path, ensuring it is properly seated in its channels, and reattach it to the latch. Finally, test the release mechanism to ensure it operates smoothly before closing the trunk.
check out the selinoid on the trunk latch
It's mounted on the Trunk Lid Latch.....
Bad gasket, latch not fully holding trunk closed.
On a 2000 Chevrolet Cavalier, the trunk latch is typically located inside the vehicle, near the driver's side door. You can find a release lever or button on the lower part of the dashboard or on the driver's side door panel. Additionally, there may be a keyhole on the trunk itself for manual access. If you're having trouble, consulting the owner's manual can provide more specific details.
69090-08010
Remove the bulb.
As far as I can see, because I crawled into the trunk to open the trunk so I could repair the mechanism that opens the trunk. No!
inside the trunk is an emergeny pull cord. when u turn the key there is a little piece on that cord that the key pulls on... u can only fix it with the trunk open though. so to open it get the remote or have a second person to open the trunk right after u press the botton. open it while the latch is rewinding
There are several reasons why the trunk of a 2000 Volkswagen Beetle might not open. A common issue could be a malfunctioning trunk release mechanism, which may be due to a faulty cable or electrical problem. Additionally, a dead key fob battery or a blown fuse could prevent the electronic release from functioning. Lastly, physical obstructions or damage to the trunk latch could also be the culprit.