To fold the rear seats flat in a 2011 Hyundai Santa Fe, first, locate the release levers on the sides of the seatbacks. Pull the levers to unlock the seatbacks, then push them down until they lay flat. Ensure that the front seats are adjusted forward if necessary to allow the rear seats to fold completely down. Make sure the seat belts are out of the way to avoid damage when folding the seats.
I just did a pump on my 02 Santa Fe, I actually found it by accident, but I had to take out the rear seats. then pull up the carpet and liner, and there is a panel under where the passenger side seat was, just take it up and you should see the fuel lines and the electrical for the pump.
Its inside/behind the glove compartment. Squeeze the sides pull the unit towards you and remove it.
take the two screws out. the back of the light is connected with a rubber plug un hooked it an pull off the light,twist the bulb out of the scoket. my advise replace all thre bulbs
To remove and replace the transmission in a 2002 Hyundai Santa Fe, first, ensure the vehicle is securely elevated and supported. Disconnect the battery, drain the transmission fluid, and remove the driveshaft, exhaust components, and any wiring or connectors attached to the transmission. After unbolting the transmission from the engine and removing the transmission mount, carefully pull the transmission out. Install the new transmission by reversing these steps, ensuring all connections are secure and refilling the transmission fluid before starting the vehicle.
$500-$600 w/ the dealer. They have to pull the radiator out to get down to the alternator underneath it. Happened to me.
remove ash-tray,remove two screws and gently pull on lower pannel. You now have access to a/c controls lights on rear of pannel. To remove top pannel just remove two screws at bottom of pannel and again gently pull pannel out.
Pull one or both straps located in the trunk top center. This will disengage the latches for the seats.
Open the glove box. There are two fastners holding the glove box. They are plastic so be carefull but you can pull them out. Once they are out look underneath and pull together the four tabs to pull the filter housing. Replace the filter and reverse the disassembly.
There are little levers you have to pull and push them forward.... these are located on right and left side from trunk access.
Remove the 3 nuts from behind the housing in the trunk. Gently pull housing from car.
why are you driving a Hyundai