0
To install a remote start assembly on a 2003 Mazda Protege, first disconnect the battery to ensure safety. Then, access the vehicle's ignition wires by removing the necessary trim panels. Connect the remote start wiring harness to the ignition, starter, and other essential wires according to the remote start kit's instructions. Finally, test the system before reassembling the trim and reconnecting the battery.
What else can I help you with?
What would make your 95 Mazda protege start and then die?
The key.
Your 94 Mazda protege wont start it cranks over but doesn't start?
There are a few reasons why a 1994 Mazda Protege won't start, but does crank. A couple of reasons could be the air flow sensor or a problem in the fuel lines.
How much is it to replace a 99 Mazda protege serpentine belt?
The cost to replace a 1999 Mazda Protege serpentine belt will vary depending on the cost of parts and cost of labor. The prices for the serpentine belt start at $14.56.
How do you get a key out of an ignition of a 1993 Mazda protege it is stuck and you cant even start it or remove the key?
i have no clue i have the same problem with my Mazda 1999 626
How much oil does a 2.0 L Mazda Protege take?
3.5 0r 3.7 qts i would start with 3.5
How do you replace wheel bearing on Mazda Protege 5?
To replace the wheel bearing on a Mazda Protege 5, start by lifting the vehicle and removing the wheel. Then, detach the brake caliper and rotor to access the hub assembly. Use a hub puller to extract the old bearing from the hub, clean the area, and install the new bearing securely. Finally, reassemble the rotor, caliper, and wheel, ensuring all components are torqued to the manufacturer’s specifications.
Why would a 1999 Mazda Protege cut out then start and run fine again like nothing happened?
check pcv valve
Your 1992 Mazda Protege will turn over but wont start what could be wrong?
battery may be dying and altenater may be going out
How do you start a 95 Mazda Protege with a screwdriver?
Do you really expect people to tell you how to steal a car? If it's your car, use the key.
Why doesn't the spark plug spark on a 2002 Mazda protege?
car stalled at red light and will not start. there is no spark from spark plug, help!
How do you replace the front turn signal bulb located on a 2001 Mazda protege?
To replace the front turn signal bulb on a 2001 Mazda Protegé, start by opening the hood and locating the turn signal assembly. Remove the retaining screws or clips holding the assembly in place, then gently pull the assembly out. Twist the bulb socket counterclockwise to remove it, replace the old bulb with a new one, and reassemble by reversing the steps. Finally, test the new bulb to ensure it's working properly.
Where is the starter located on mazda protege 5 2002?
It is located right behind the ignition. It is important that this part is working correctly so that your car will start.
