Take your car to the closest Mazda dealer and get it fixed there. They charge only 1 hour ($60) for the labor. I did it last week, by the way, what it is expensive is the handle !!!. Otherwise, remove the two screws (handle and pocket) and unplug the panel starting from the bottom. The problem is not removing the side panel, the problem is replacing the handle itself.
check Mazda forum. Answer is within
Just try opening your door to get out and it will probably pop right off into your hand! That's what happened to me this morning. 2001 Mazda Tribute LX V6 piece of JUNK!
To remove the cover on the emergency brake handle of a 2006 Mazda Tribute, start by gently prying off the plastic cover at the base of the handle using a flathead screwdriver or a similar tool. Be careful to avoid damaging the plastic. Once the base cover is off, you can unscrew any visible screws that may be securing the handle cover. After removing the screws, the upper cover should lift off easily.
2005 model
You have to jack the motor up
take off a retaining nut?
It should have disk brakes on the rear, no need to adjust. If you need to adjust the E-brake do it from the handle in the car (would need to remove trim to get to cable)
To remove the rear door handle on a 2002 Mazda Protege, first, ensure the door is open and then remove the interior door panel by unscrewing any visible screws and gently prying it off with a trim tool. Next, locate the handle's mounting screws, usually found inside the door cavity, and remove them. Disconnect any linkage or wiring attached to the handle, then carefully pull the handle out from the exterior side of the door. Reassemble in reverse order after replacing or repairing as needed.
How mani LBS feron of mazda tribute 2004 .
The Mazda Tribute seats 5 adults.
How to replace a starter on a 2001 Mazda Tribute?
you just pull it out, its held by small pressure clips