I have a 1999 Forester, but I imagine the 2003 is similar in this regard. You don't actually need to remove the headlamp to replace the bulb. On my car, I unplug the wire from the bulb at the back of the headlamp, remove the large rubber piece around the back of the bulb, unclip the clips that hold the bulb in place, remove and replace. Cheers! Mark This is a good answer and is so just as stated. Thanks Mark! RicT
Open hood, remove headlamp bulb from headlamp assembly, remove (1) 10mm bolt from top of headlamp assembly, next remove (3) 10mm bolts from behind headlamp assembly, pull headlamp forward ( you may have to pry gently from the right side). Remove turn signal bulb-Done!
To replace the headlamps on a 1995 Subaru SVX, start by opening the hood and locating the headlamp assembly. Remove the retaining screws or clips holding the assembly in place, then gently pull the assembly forward. Disconnect the wiring harness from the back of the headlamp, replace the bulb by twisting it counterclockwise, and then install the new bulb by twisting it clockwise. Reconnect the wiring harness, reposition the headlamp assembly, and secure it with the screws or clips.
To remove the headlamp assembly from a 2008 Buick LaCrosse, first, open the hood and locate the headlamp assembly. Remove the screws or bolts securing the assembly, typically found at the top and possibly the side of the assembly. Disconnect the wiring harness by pressing the tab and pulling it away from the assembly. Finally, gently pull the headlamp assembly out of its housing to complete the removal.
Open the hood to the engine compartment. Remove the headlamp wiring harness. Remove the headlamp assembly retaining bolts. The headlamp will come out.
according to the manual you have to remove the front grill and plastic lamp cover then unbolt the lamp housing to remove it then replace the bulbs - unfortunately it is very vague as to the exact procedure for removing the front grill. I dont think you actually have to remove the headlight assembly, you open the hood and get to the bulb through the back side of the headlight.
With the hood open remove the (2) two headlamp assembly bolts from the upper fascia support. Slide the headlamp assembly outward enough to release the headlamp bracket tabs from the slots in the upper fascia support. Position the headlamp assembly away from the vehicle body to access the electrical connector. Disconnect the electrical connector from the headlamp assembly. Remove the headlamp assembly from the vehicle. If you wish to change the halogen bulb: Disconnect the electrical connector from the headlamp bulb/socket. Remove the headlamp bulb/socket retainer ring from the headlamp, by turning counterclockwise. Remove the headlamp bulb/socket from the headlamp assembly. Hope this helps. G These instructions are similar from around '96 to '03 grand prix model years all trim levels.
To remove the headlamp assembly on a 2000 Toyota Solara, start by opening the hood and locating the headlamp assembly. Remove the screws or bolts securing the assembly, typically found on the top and side of the unit. Disconnect the electrical connectors and gently pull the headlamp assembly out of its housing. Be cautious not to damage any clips or wiring during the process.
Remove the (2) two headlamp assembly bolts from the upper fascia support. Slide the headlamp assembly outward enough to release the headlamp bracket tabs from the slots in the upper fascia support. Position the headlamp assembly away from the vehicle body to access the electrical connector. Disconnect the electrical connector from the headlamp assembly. Remove the headlamp assembly from the vehicle. If you wish to change the halogen bulb: Disconnect the electrical connector from the headlamp bulb/socket. Remove the headlamp bulb/socket retainer ring from the headlamp, by turning counterclockwise. Remove the headlamp bulb/socket from the headlamp assembly. Hope this helps. G These instructions are similar from around '96 to '03 grand prix model years.
To remove the headlamp assembly on a 2003 Acura CL, first, open the hood and locate the headlamp mounting bolts. Remove the bolts using a socket wrench, and then gently pull the headlamp assembly forward. Disconnect the electrical connectors from the back of the assembly and carefully lift it out. Be sure to handle the assembly gently to avoid damaging any components.
simply remove the two screws located on the top of the headlamp assembly and then pull the headlamp assembly forward to gain access to the light bulbs
With the hood open remove the (2) two headlamp assembly bolts from the upper fascia support. Slide the headlamp assembly outward enough to release the headlamp bracket tabs from the slots in the upper fascia support. Position the headlamp assembly away from the vehicle body to access the electrical connector. Disconnect the electrical connector from the headlamp assembly. Remove the headlamp assembly from the vehicle. If you wish to change the halogen bulb: Disconnect the electrical connector from the headlamp bulb/socket. Remove the headlamp bulb/socket retainer ring from the headlamp, by turning counterclockwise. Remove the headlamp bulb/socket from the headlamp assembly. . G These instructions are similar from around '96 to '03 grand prix model years all trim levels.