The old Toyota previa models 90-99 are the opporsite way around so indicator arm is on the right side and wiper arms is on the left
To change the rear wiper motor on a 1991 Toyota Previa, first, disconnect the negative battery cable to ensure safety. Remove the wiper arm by unscrewing the nut and pulling it off, then access the motor by removing the rear interior panel. Disconnect the electrical connector and unbolt the motor from its mounting bracket. Install the new motor by reversing these steps, ensuring everything is securely reconnected.
To change the driver wiper blade on a Toyota Matrix, lift the wiper arm away from the windshield. Press the small tab on the underside of the wiper blade where it connects to the arm and slide the blade downwards to remove it. Align the new wiper blade with the arm and slide it up until it clicks into place. Finally, gently lower the wiper arm back onto the windshield.
if you can manually move it with you hands them u need to tighten the nut on the arm
Remove wiper arm caps, nuts & arms. Remove cowl louver cover. Disconnect wiper motor electrical connector. Remove 6 bolts and remove wiper linkage assembly. Disconnect wiper link from wiper motor. Remove 4 screws and wiper motor from firewall.
To replace a wiper motor on a 1994 Toyota Corolla, remove the rubber stopper that cover the hardware attached to the wiper arms. Then grab the wiper arm and jiggle it back and forth until it comes off. Remove the old one and slip the new one on.
Remove plastic cap. Remove nut. Pry up wiper arm.....
Remove the wiper arm retaining clip. The retaining clip will be just below the wiper arm connection. Hold the retaining clip in and the wiper arm will come off.
A wiper arm on a 2001 Honda Civic is screwed on. To remove it unscrew the mounting hardware and take off the wiper arm.
First remove the plastic cover at the fixed end, this will allow you to lift the wiper arm up and you can then unclip
you just pick up the wiper arm
# Raise the rear wiper arm finish cap to expose the wiper arm nut. # Remove the rear wiper arm nut (1). # Lift the rear wiper arm assembly (2) away from the rear window and remove the wiper arm from the pivot shaft. The cap tilts up toward the arm