0
To remove the wiper rod on a 1990 Mitsubishi Montero, first, lift the wiper arm away from the windshield to expose the pivot nut. Use a socket wrench to remove the nut securing the wiper arm to the wiper rod. Once the nut is removed, gently wiggle and pull the wiper arm off the rod. If necessary, use a puller tool to help loosen it without damaging the arm or the rod.
What else can I help you with?
Where is fuse for computer in Mitsubishi montero 1990?
The fuse for the computer in Mitsubishi Montero 1990 is located under the plate called fuse panel. This is where you will find the fuse.
How do you adjust wiper stop position on 1990 Mitsubishi Montero?
One way would be to remove and replace the wiper arm itself. There is usually a cap covering the nut holding on the wiper arm at it's pivot point, remove the cap, followed by the nut. Then pry the wiper arm off it's spline gear, and reposition it so it stops where you want it to. Be aware that it can take considerable pressure to pry off some wiper arms. Good luck!
Is a 1990 Montero interferrance engine?
The 1990 Mitsubishi Montero 3.0 V6 is listed as a non-interference engine. Replace the belt every 60,000 miles.
What kind of transmission fluid does a 1990 Mitsubishi Montero take?
Dexron III
How many valves on a 1990 Mitsubishi montero V6 engine?
1990 will most likely be SOHC, so 12 valves.
Where can i see a picture of a 1990 Mitsubishi montero engine?
go to the makers web site or google
Where is the automatic transmission temperature sensor located on a 1990 Mitsubishi montero LS?
The automatic transmission temperature sensor, on your 1990 Mitsubishi, is located on the top of the transmission. The sensor will have to electrical wires going to it.
What motors will fit a 1990 Mitsubishi Montero besides the 3.0s?
Try calling your local wrecking yard as they have crossover books.
Why is the wheel LOCK LIGHT ON MY 1990 MITSUBISHI MONTERO?
your front hubs are still locked.make sure it is in 2 wheel drive,and try backing up to release them.
Why does power window driver side on 1990 Mitsubishi montero go down but won't come up until several trys?
Relay switch in door is bad, replace relay switch. Remove interior door panel and you will find relay switch.
In a 1990 Mitsubishi Montero why would your hazard lights work but your turn signals not?
check your bulbs some bulbs have two filament on them one may be out and the other working.
What would cause a front crank seal to leak on a 1990 Mitsubishi montero 3.0 liter v6 engine?
A loose crank pully retaining bolt will make it leak.
