I'm going to guess that its the same as the 2007 MDX. There is a black trim that the license plate lights recess into. You will need to remove the 5 or so screws and remove the rear view camera cover if you have one to get to the remaining screws. Once the screws have been removed you will need to bend the trim slightly to free the tabs at both ends. Once the trim has been removed you will see the light covers. The covers have lips on one side to push and release the cover latch. I had a little trouble and used a flat screwdriver to help remove the cover. Once the cover is removed you will have access to the bulb. Do everything in a reverse order to put it back together.
You need to remove the liner on the trunk lid. That will give you access to the license plate lights housing. Remove the sockets by twisting 1/4 turn and replace bulbs. Size for bulbs are 2825
05+ Honda Odyssey license plate lights. Pop out the license plate lights in the rear. There are two of them. Use a very thin flathead screw driver and pop out the sides of the inner clear light assembly. They are on the sides. Once that is done, remove the light bulb and replace with a new bulb. Pop in the clear light assembly cover. Turn on lights to see if the bulb is working and it is is then you're done. Approximately 10-15 minutes total.
if your under miles its under warrenty
To replace the rear license plate light on a 2008 Kia Rio 5, first, open the trunk and locate the license plate light assembly. Carefully pry off the cover using a flat-head screwdriver or a similar tool. Remove the old bulb by twisting it counterclockwise, then insert the new bulb and reinstall the cover. Finally, test the light to ensure it’s working properly.
To change the license plate bulbs on a 2008 Ford Taurus, first, open the trunk and locate the license plate light assembly. Use a flathead screwdriver to gently pry off the light cover. Remove the old bulb by twisting it counterclockwise, then insert the new bulb by twisting it clockwise. Finally, replace the light cover and ensure it’s securely in place.
To change the license plate bulbs on a 2008 Hyundai Santa Fe, first, open the rear hatch and locate the license plate light assembly. Use a flathead screwdriver to gently pry the light assembly out of its housing. Once removed, twist the old bulb counterclockwise to release it, then replace it with a new bulb by twisting it clockwise. Finally, reinsert the light assembly back into its housing and ensure it is securely in place.
The 2006 Legacy license plate bulb is accessed by removing the liner in the trunk and un screwing the plastic socket.
It will be necessary to remove the front license plate and bracket. Remove license plate from bracket. Using a 3/16" drill bit, drill out the two pop rivets that hold the bracket to the bumper. This is from a a bull bar installation guide for a 2008 Ford Escape/2008 Mercury Mariner.
4 screaws remove lences
How do you replace the side marker lights on a 2008 saturn vue?, they seem to be hid completely in the body.
You can replace the marker lights on a 2008 GMC Yukon Denali by removing the retaining screws and disconnecting the wiring harness. The bulb can then be unscrewed and a new bulb put in place.
how do you remove dome light lens on 2008 trailblazer