There are two (2) lights directly above the license plate. Each light has two (2) screws. Remove these screws and the covers. Lights pop out with little effort. Replace bad bulbs with size 194 lights. These are approx $2 at Walmart or an auto parts store. Once bulbs are replaced, reattach covers with the screws and you should be good to go.
To replace the headlight bulb in a 1994 Nissan Sentra first prop the hood of the car. Locate the headlights and remove the bulbs from the housing. Install the new bulbs.
To replace the console lights in a 2008 Nissan Sentra, first, remove the console trim by gently prying it off with a plastic trim tool. Once the trim is removed, locate the bulbs behind the console; they may twist out or require unscrewing. Replace the old bulbs with new ones, ensuring they are of the correct type, and then reassemble the console trim by snapping it back into place. Finally, test the lights to ensure they are functioning properly.
To replace the taillights on a 2001 Nissan front first prop the hatch open. Locate the rear lights plastic housing and remove them to find the bulbs. Replace the bulbs.
check your bulbs
the screws come off and you replace it
The headlight bulb is the part to replace on the 96 Sentra, unless the whole headlight unit was damaged. I suggest buying the bulbs in pairs and replace them both. Then you don't have to do the whole process over in a month when the other bulb goes! The Sentra's bulbs are held in by a wire clip. Looks like it was made from an old coat hanger. Its a tad tricky to get it to unhinge, but it will pop open. Just unplug the old bulb and pop the new one in. Then fiddle with the wire until its clipped back into place. Do this in the daylight because its no fun trying to play with that darn wire in the dark, trust me!
through the rear package compartment under the matting
Remove the taillight assembly to gain access to the bulbs
To change the light bulb on a Nissan Micra first lift the hood of the car. Find the headlight housings the pull the light bulbs from the ballast. Replace the bulbs.
push up and turn on the housing
You need to remove the liner on the trunk lid. That will give you access to the license plate lights housing. Remove the sockets by twisting 1/4 turn and replace bulbs. Size for bulbs are 2825
Try the fuse and then the bulbs.