0
What else can I help you with?
What is the ignition timing supposed for a 2.2L 1993 subaru legacy?
The 1993 Subaru Legacy 2.2 liter engine ignition timing is the sequence that allows the engine to run smoothly. The ignition timing is synchronized with the crankshaft position sensor.
How do you replace crankshaft sensor?
how to replace crankshaft sensor on Corsa 1-2 2002 .Which parts require removing to replace unit
How do you replace o2 sensor on 1998 subaru legacy?
Use a 7/8" O2S wrench, socket, or crow's foot to unscrew the sensor, then put a new one in.
Could the mechanic damage the crankshaft sensor while replacing the timing belt and pulley?
I had the timing belt on a 2001 Subaru Legacy replaced. After getting the car back, it was misfiring, and eventually the engine shut down. Dealer diagnosed faulty crankshaft sensor. Anybody else have this experience?
How do you replace the engine coolant temperature sensor on 1997 subaru legacy?
You could look here:http://www.lovehorsepower.com/SubaruDocs/CoolantTempSensor.htmlThis page shows the coolant sensor and how to replace it.'95 Subbie and '97 should be similar.
Where is the MAT sensor on a 95 Subaru legacy?
Unsure where you'll find the bugger, get your auto sparky to replace it (its a MAP sensor) as it can cause real headaches if it dies, engine rebuilds and such
How do you replace bank 1 sensor 1 on subaru legacy?
To replace Bank 1 Sensor 1 (the upstream oxygen sensor) on a Subaru Legacy, first, ensure the engine is cool and disconnect the battery. Locate the sensor on the exhaust manifold, then use a suitable oxygen sensor socket or wrench to unscrew it. Install the new sensor by threading it in by hand, then tighten it securely without over-torquing. Finally, reconnect the battery and clear any diagnostic trouble codes if necessary.
How do you replace the oxygen sensor on a 2001 subaru legacy?
To replace the oxygen sensor on a 2001 Subaru Legacy, first, locate the sensor, which is typically found on the exhaust manifold or the catalytic converter. Disconnect the negative battery terminal to prevent any electrical issues, then unplug the old oxygen sensor's connector. Use an O2 sensor socket or a wrench to carefully unscrew the old sensor, and install the new one by threading it in and tightening securely. Finally, reconnect the sensor's electrical connector and the battery terminal.
How many wires on a after cat O2 sensor subaru legacy?
four4
Where is the speed sensor on a 91 subaru legacy?
In a 1991 Subaru Legacy, the speed sensors can be found on the driver's side of the transmission. They are located towards the rear, and there are three of them.
How do you replace the crankshaft sensor in a 1985 Oldsmobile Calais Supreme LN7 3.0 liter engine?
changing the crankshaft sensor
How do you replace crankshaft sensor on a VW jetta 2.5l 2006?
where is the crankshaft position sensor on 2.5 liter vw jetta
