answersLogoWhite

0

What else can I help you with?

Related Questions

Where is the blower resister located on a 99 Nissan sentra?

The 1999 Nissan Sentra has a blower resistor in the air vents. This mechanism regulates the amount of air entering the cabin.


Where is the blower motor resistor in a 2008 Nissan sentra?

to the right of the gas peddal


Where is the blower motor resistor located on 2008 Nissan Sentra?

They are generally found close to the blower motor.


Why does your 1997 Nissan Sentra blower works only on position 4?

Defective blower motor resistor pack.


How do you replace blower motor resistor on 2003 Nissan altima?

One can replace blower motor resistor on 2003 Nissan altima by removing the old using spanners and replacing it with a new one.


What causes an ac-heater in a Nissan Sentra to only blow on high?

you need a new blower motor resistor


1995 Nissan Sentra blower motor resistor installation?

Locate the resistor under the dash attached on the blower motor housing. Disconnect the wire harness connector. Remove the resistor and install a new one.


I have a 2000 Nissan sentra. My blower fan switch is numbered 1 to 4 and when i turn it on it only works on number 4.?

Blower resistor switch


What do you do if your 1998 Nissan sentra blower motor only blow on high speed?

More than likely the blower motor speed resistor burned out.


2000 sentra blower only works on high?

You need to replace the blower motor resistor located near the glove box.


How you change the blower motor resistor in Nissan maxima 2002?

To change the blower motor resistor in a 2002 Nissan Maxima, locate the blower motor resistor under the glove compartment on the passenger side of the vehicle. There is a clip that is depressed and then the resistor will slide out. Remove both ends of the resistor and then replace with the new resistor.


Where is the blower motor resistor on a 1998 Nissan Sentra?

Under the dash on the passenger side. There are two screws to remove it, and the replacement goes right in. It took me about 30 seconds to replace it once I located it