what engine?
1.6, or 1.8 Liter.
1.6 the CMP (real name) is inside the distributor , so buy new disty.
no parts inside disty are sold.
1.8L (and bigger ) there are 2.
on 1.8L you
1: unbolt it
2; then index the offset key and plug in the new.
3: then insert a jumper wire int he DLC , called the freeze jumper.
4: strobe light time the CMP running at idle hot.
5: open hood, look up ,see white sticker, see xxx BTDC, that is your spec timing
In order to replace the camshaft position sensor, you would need to disconnect the electrical plug holding it in. Using a socket, hold down the bolt and remove the camshaft position sensor.
how do you replace the camshaft position sensor on a 1997 plymouth voyager 3l
where is the camshaft position sensor located on a 1999 Oldsmobile intrigue
how to remplace position of oxigen sensor
How do u replace the camshaft sensor for a 2000 Nissan xterra 3.3L and where is its locatoin
At the back of the engine, looks like a distributor!
I changed only the camshaft position sensor on my 2000 Kia Sportage. So I don't think so.
Locate the camshaft sensor in your car. Disconnect the electrical plug on the sensor. Remove the bolt that holds it in place. Twist the the sensor to remove it and place in the new one.
do you need to take off the timing belt to replace a camshaft position sensor on a 2006 kia sorento
The camshaft position sensor is located near the thermostat housing. You should replace the crankshaft position sensor as well. This one is much harder to locate....it is on the backside of the engine that is between the firewall and the engine block. Both use the same sensor.
the camshaft position sensor is on the left side of the engine , at back on the upper side . you have to demont the conector , than unscrew and replace it
If I'm not mistaken, I think the camshaft position sensor on these engines is built into the distributor. You'd have to replace the whole thing.