0
To replace the clutch on an Acura RSX, start by safely lifting the vehicle and removing the front wheels. Disconnect the battery, drain the Transmission Fluid, and remove the transmission by detaching the drive shafts, starter, and any necessary mounts. Once the transmission is out, remove the old clutch and pressure plate, clean the flywheel, and install the new clutch kit according to the manufacturer’s specifications. Reassemble all components in reverse order, ensure everything is properly torqued, and refill the transmission fluid before testing the vehicle.
What else can I help you with?
How much does it cost to replace a clutch on a Acura RSX?
i pay 200 for the height performance clucth and i pay 200 more for replace it.
When do you replace the timing chain On the 2002 Acura RSX?
75000 miles
How do you install a clutch on a Acura RSX type s?
This is a compleat write up with pics. it should help http://customdc5.my-php.net/diy/clutch
How much does it cost to replace a windshield on a 2003 Acura RSX?
The price for a replacement windshield for a 2003 Acura RSX varies depending on the region. A typical price ranges from about 200 dollars to 400 dollars.
What type of coolant should does Acura RSX?
What type of coolant should acura rsx take
Does the Acura RSX have a turbocharger?
no
Does a 2006 Acura RSX Type S have a timing chain or a timing belt?
The Acura RSX has a timing chain belt.
How to replace clutch 1989 Acura Legend?
In order to replace a clutch on 1989 Acura Legend, you would have to remove the old one. You will do this by removing the jam nut that holds the pedal and disconnecting it from the throttle cable and replace it with a new one.Ê
Where is the 3rd clutch pressure switch for an Acura RSX located?
The 3rd clutch pressure switch on an Acura RSX is typically located on the transmission. Specifically, it can be found on the side of the transmission housing, near the rear of the engine bay. Access may require moving some components or removing the battery for better visibility. Always consult the vehicle's service manual for precise locations and instructions.
Will 05 Acura RSX fog lights work on 03 rsx?
Yes
Why does your Acura RSX takes long to start after sitting for a while?
My super sport toyota Camry does that and we had to replace the ground to the battery
How do you bleed the clutch system on a Acura RSX?
To bleed the clutch system on an Acura RSX, start by locating the clutch slave cylinder, which is typically mounted on the transmission. Use a wrench to loosen the bleed screw on the slave cylinder, then have an assistant pump the clutch pedal several times and hold it down. While the pedal is held down, tighten the bleed screw to prevent air from entering, then release the pedal. Repeat this process until there are no air bubbles in the fluid that emerges from the bleed screw, and ensure the clutch fluid reservoir is topped off throughout the process.
