To replace the Power Steering belt on a 1991 Mazda 323, first, ensure the engine is off and cool. Remove the belt by loosening the tensioner pulley and then sliding the old belt off the pulleys. Next, install the new belt by routing it around the pulleys according to the belt diagram, then adjust the tensioner to ensure proper tightness. Finally, double-check the alignment and tension of the belt before starting the engine.
good idea
Underneath the drivers seat
To install the power steering belt on a 1991 Mazda Miata, first, ensure the engine is off and cool. Loosen the tensioner bolt and the mounting bolts for the power steering pump to allow adjustment. Place the new belt around the power steering pump pulley and the crankshaft pulley, then adjust the pump to achieve proper tension. Finally, tighten the tensioner and mounting bolts, ensuring the belt is secure and has the appropriate tension.
To fix the power steering on a 1991 Toyota MR2, first check the power steering fluid level and top it off if it's low. If the fluid is leaking, inspect the hoses and connections for any signs of damage or wear and replace them as necessary. Additionally, examine the power steering pump for any issues, such as noise or failure to operate, and replace it if needed. Finally, ensure the steering rack is functioning properly and not damaged; if it is, consider rebuilding or replacing it.
In the power steering pump
IN THE POWER STEERING PUMP.OPEN THE HOOD,STAND IN FRONT OF TRUCK LOOK TO YOUR LOWER LEFT,FOLLOW THE DRIVE BELTS,ONE BELT IS CONNECTED TO POWER STREEINGPUMP,UNSCREW CAP ON TOP OF UNIT. GOOD LUCK,,toro2
A 1991 VW Jetta's power steering reservoir is located towards the front of the engine bay. The unit can be seen placed on top of the power steering pump.
This happened to my van and it was the steering gear box. I had to replace it, i did it myself and it cost around 200. It took me 2 hour to fix.
To replace the power steering belt on a 1991 Mercury Capri, first, ensure the vehicle is turned off and safely supported. Locate the power steering pump and identify the tensioner mechanism. Loosen the tensioner bolt and remove the old belt from the pulleys. Finally, install the new belt, ensuring it's properly seated on all pulleys, then adjust the tension before tightening the tensioner bolt.
Under steering wheel and on upper left side of engine bay
Yes, in the steering wheel. Later models will have passenger-side airbags.
pritt stick