0
To replace the side moldings on a 1992 Integra, start by carefully removing the old moldings using a plastic trim removal tool to avoid damaging the paint. Clean the surface where the new moldings will be applied, ensuring it's free of debris and old adhesive. Align the new moldings with the vehicle's body, then press them firmly into place, ensuring a secure bond. Finally, check that the moldings are properly aligned and adhere well to the surface.
What else can I help you with?
How do you replace the driver's side electric window switch on a 1992 Acura Integra?
The driver side electric window switch on a 1992 Acura Integra is reached by removing the door panel. Unbolt the switch from the mounting bracket and disconnect the wiring from the harness. Replace the unit.
How do you replace the rear side marker bulb on a 1994 Acura Integra?
From in the trunk
Where is a fuse box diagram for a 1992 Acura Integra?
what slot do the left power set belt fuse go in the fuse box for 1992 acura integra Under the driver side dash
Where is the defrost relay located on a 1992 acura integra?
below the left side of the instrument panel behind the kick panel on the fuse box
How do you replace a side mirror on a 1992 Infiniti Q45?
Go to the repair shop
How do you replace the side view mirror on a 1992 Chevrolet full size blazer?
how do i tighten my side mirrors on my 98 blazer?
How do you replace the passenger side CV axle on a 1992 Nissan Stanza XE?
Easy fix!
How do you check transmission fluid on an acura integra 1992 standar?
There is a fill hole in the side of the transmission towards the middle facing inward. The fluid should be just high enough to not run out of the hole.
Can 2000 Lincoln Navigator running fit on a 1998 Lincoln Navigator?
You mean the running boards? Structurally, yes... but the plastic body side moldings from 1998/99 to 2000/02 are completely different. It would look like crap and either have gaps or require cutting/shaping to fit the plastic parts on. To switch over to a 2000 setup, you would need: Front fender wheel opening moldings Front door body side moldings Rear door body side moldings Rear quarter "dog leg" moldings Fasteners for a 2000 Blood Sweat Tears It's do-able, but they are different. I have been involved with stretching both a 1998 and a 2000 into limousines. I even have fiberglass molds for the stretched body side moldings. Short Answer: get 1998s if you're just replacing damaged running boards. If you're trying to "sexy" up your 'gator, look at 2005-up motorized ones. They can be adapted to your 1998.
How do you replace your 1990 integra distributor cap?
there should be three bolt on the side of the cap, remove them and make sure yoiu mark where your sp wires goes.If not LOUD BACK FIRE..........
How do you replace driver side exterior door handle to a 1992 Nissan Pathfiner?
W/ a new one
How do you replace the driver's side inside door handle of a 1992 Toyota Corolla?
anyone has pictures out there for how to replace door handles for 92 Toyota corolla?
