I now assume we are talking about the front parking light. Subaru service manual recommends removing the headlight assembly and then changing the park. light. This will almost certainly render a headlight adjustment, which actually isn't all that hard (I usually just pick a flat piece of asphalt and a wall....and then get i t verified at our annual auto inspection) On a late 99 or early 00 Legacy I managed to change it without removing the headlight by loosening the shroud under the headlight and GENTLY bending it away so an arm coulod be inserted. You can then get to the park.light mounting which is located at the bottom of the headlight. It's hard, but not impossible. Prolly easiest on a ramp, but I did it on the driveway. If one has short or excessively large arms/hands this could prove to be a problem since the actual working area is a bit cramped ;-) Just don't get yourself run over while under the car. Good luck.
"Parking Light Switch". See page 3-16 of your 'OWNER'S MANUAL" for description.....
To change the park light on a Subaru Impreza prop the trunk lid open and locate the taillight housing. Remove the plastic cover and the bulbs for the parking lights. Replace the bulbs.
To replace the front right parking light on a 2006 Subaru Impreza WRX STI, first, open the hood and locate the headlight assembly. Remove the screws or clips securing the assembly, then gently pull it out to access the parking light bulb. Twist the bulb socket counterclockwise to remove it, replace the old bulb with a new one, and reassemble everything by reversing the steps. Ensure all connections are secure before closing the hood.
To replace the front driver’s side parking light on a 2006 Subaru WRX, start by opening the hood and locating the headlight assembly. Remove the plastic cover or the screws securing the assembly, and carefully pull it out. Disconnect the wiring harness from the parking light, then twist the bulb socket counterclockwise to remove the old bulb. Insert the new bulb into the socket, reconnect the wiring, and reassemble the headlight assembly.
To replace the parking light bulb on a 2005 Subaru Forester, first, open the hood and locate the back of the headlight assembly. Remove the bulb socket by turning it counterclockwise. Pull the old bulb straight out and insert the new bulb into the socket, ensuring it’s secure. Finally, replace the bulb socket back into the assembly and turn it clockwise to secure it.
To replace front parking light on a 1999 Ford Taurus, lift the hood and remove the bolt holding the parking light housing cover. Twist the parking light off and replace with a new one.
To replace the parking light bulbs, remove the screw on top of the headlight and pop out the clearance light. The parking light bulb will be accessible after this removal.
To change a fog light in a 2008 Subaru Legacy, first, ensure the vehicle is off and parked on a level surface. Locate the fog light assembly beneath the front bumper, then remove the plastic cover or access panel if necessary. Twist the fog light bulb socket counterclockwise to release it, pull out the old bulb, and replace it with a new one. Finally, reinsert the socket, secure it, and replace any covers or panels.
Its located on the drivers side of the transaxle.
you have to replace the parking light bold because is the same as the brake light so just replace the light bold I think is the middle one between turning light and backing light. you have to replace the parking light bold because is the same as the brake light so just replace the light bold I think is the middle one between turning light and backing light.
The most likely answer is that the parking light switch on top of the steering column is turned on. --Ken The parking light switch is turned off,the engine is turned off,they are still flashing
Replace the bulb