your thermostat should be located on the drivers side of the engine underneath the distributor behind the inlet for the bottom hose. remove the two nuts and pull the inlet off.
Where is the thermostat located on a 1996 Toyota Tercel?
where is the thermostat located in a 1999 Toyota Camry located and how do you replace it.
Where is the thermostat located and how do you replace it on 1992 toyota camry 4 cylinder ingine
On my '91 it's below the thermostat.
The thermostat on a 1998 Toyota Corolla is located next to the alternator. The alternator may have to be taken off to replace the thermostat.
Should be in a removable housing at the engine end of the upper radiator hose
To replace the thermostat on a 1997 Toyota Tercel, start by draining the coolant from the radiator and removing the upper radiator hose connected to the thermostat housing. Next, unbolt the thermostat housing, remove the old thermostat, and clean the mating surfaces. Install the new thermostat with the spring side facing the engine, reattach the housing, and reconnect the radiator hose. Finally, refill the cooling system with coolant and check for leaks.
The starter on a 1991 Toyota Tercel is located in the front of the engine. It will be located on the left side.
In a 1983 Toyota Tercel, the thermostat is located in the engine compartment, specifically at the end of the upper radiator hose where it connects to the engine. To access it, you'll need to remove the hose and the thermostat housing, which is typically secured by bolts. Make sure to drain some coolant before starting the procedure to avoid spills.
At the top end of the lower radiator hose within the water outlet. I hope this helps you. Rob
at the top hose from rad. at engine
To change the thermostat on a 1997 Toyota Tercel, start by ensuring the engine is cool and disconnect the negative battery cable. Drain the coolant from the radiator, then remove the upper radiator hose connected to the thermostat housing. Unbolt the thermostat housing, take out the old thermostat, and replace it with a new one, ensuring the gasket is properly seated. Reassemble everything by reversing the steps, refill the coolant, and check for leaks.