Ignition Switch
REMOVAL & INSTALLATION
Toyota Tercel 1984 - 1994 Repair Guide
REMOVAL & INSTALLATION
See Figure 1
CAUTION
On models equipped with a Supplemental Restraint System (SRS) or "air bag,'' work must NOT be started until at least 90 seconds have passed from the time that both the ignition switch is turned to the LOCK position and the negative cable is disconnected from the battery.
1. Disconnect the negative battery cable.
2. Remove the screws which secure the steering column upper and lower covers.
3. Turn the ignition key to the ACC position.
4. Push the lock cylinder stop in with a small punch or screwdriver.
Page 1 of 3 AutoZone.com | 1992 Toyota Tercel 1.5L FI SOHC 4cyl | Repair Guides | Chassis Electri ... 6/17/2009 http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?chapter ...
On some vehicles, it may be necessary to remove the steering wheel and combination switch first.
To install:
Fig. Fig. 1: Depressing the lock cylinder stop tab
5. Withdraw the lock cylinder from the housing while depressing the stop tab.
6. Remove the ignition switch retaining screws, then withdraw the switch from the lock housing.
7. Align the locking cam with the hole in the ignition switch, then insert the switch into the lock housing. 8. Secure the switch with its screws.
9. Make sure both the lock cylinder and the column lock are in the ACC position. Slide the cylinder into the lock housing until the stop tab engages the hole in the lock.
10. Install the steering column covers.
11. Engage the ignition switch connector.
12. Check the ignition switch operation in all positions.
Back to Top
Page 2 of 3 AutoZone.com | 1992 Toyota Tercel 1.5L FI SOHC 4cyl | Repair Guides | Chassis Electri ... 6/17/2009 http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?chapter ...
Page 3 of 3 AutoZone.com | 1992 Toyota Tercel 1.5L FI SOHC 4cyl | Repair Guides | Chassis Electri ... 6/17/2009 http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?chapter ...
what is the tire pressure for a 1992 toyota tercel?
5.25"
where do you find the filling plug for the gear oil on a 1993 Toyota tercel
yes u can 91 through 94 is the same
The fuse box on a 1992 Toyota Tercel is located under the dash, near the hood release. It contains the protective fuses for most of the electrical system.
it should they r the same
the fuses for a the A/C for the tercel are located behind the glove box
Check your Toyota owner"s manual, if it show you yes , then do it!
2 1/2"
Apparently 1000 in BC
Begin by removing the retaining ring at the top of your 1992 Chevy ignition switch. The ignition switch will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install the new ignition switch.
Type your answer here... How do you remove ignition switch from 1992 ford explorer?