With the car off you will need to:
1. (without putting your foot on the brake) hit the start button twice.. Then
2. Hit the odometer stem to make it go to trip a (where the odometer reads.)
3. Turn the car back off and then hold in the odo pegand
4. Hit the start button twice again ( without your foot on the brake) and it will reset.
To turn off the maintenance light on a Lexus GS350, first, turn the ignition to the "ON" position without starting the engine. Next, press the gas pedal three times within five seconds. Finally, turn the ignition off, and when you restart the vehicle, the maintenance light should be reset. If the light remains on, you may need to check for any ongoing maintenance issues.
There is an Off/On switch on the dash facing straight down towards the floor. It is near the steering wheel and you need to be almost lying on the floor facing up to see it.
To reprogram a key for a Lexus ES350, first ensure you have a working master key. Insert the master key into the ignition and turn it to the "On" position without starting the engine. Then, turn the key back to the "Off" position and remove it. Within 5 seconds, insert the new key and turn it to the "On" position; this should program the new key. If you encounter issues, consult the owner's manual or visit a dealership for assistance.
While your ignition is own reset your mileage to the total mileage. Turn the ignition off and then back on while holding in the odometer button until the maintenance light flashes several times and resets.
To reset the maintenance light on a Lexus ES 350, first, turn the ignition to the "ON" position without starting the engine. Next, press the trip meter reset button until the odometer displays "000000." Turn the ignition off, then press and hold the trip meter reset button again while turning the ignition back to the "ON" position. Release the button after the maintenance light blinks and turns off, indicating the reset is complete.
probably have to have a Lexus dealer turn it off
open the switch with reset button pressed until disapear for 5 secs dont start the engine
From Lexus Web site: This procedure should be used to reset the light when the maintenance has been performed:1. Turn ignition switch to the ON position.2. Set the Odometer / Trip Display to the ODO mode3. Turn the ignition switch to the OFF position.4. Depress and HOLD the Trip Meter RESET button while turning the ignition switch to the ON position.5. The Service Maintenance Reminder Light will: a. Illuminate solidly for 3 seconds. b. Blink for 2 seconds. c. Illuminate solidly for 1 second. d. Turn off.6. Release the Trip Meter RESET button.7. Turn the ignition to the OFF position.8. Turn the ignition to the ON position, and confirm that the Service Maintenance Reminder Light goes out.NOTE: If the light continues blinking in step 5a, turn the ignition off, and repeat the procedure from step 1.ignition off, and repeat the procedure from step 1. Depending on the model, this may not work. Your maintenance light is a reminder for every 5000 mile to at minimum have your oil and filter changed.
Make sure the odometer is set to total miles not trip.With the key in the off position, push in and hold the odometer reset button (ODO).Turn the key to the on position without starting the car.Continue to hold down the odometer reset button until the maintenance required light goes off (about 20 seconds). You'll see the bars running across the screen and the light will turn off.
HOW TO TURN OFF THE MAINTENANCE LIGHT ON 2002 HONDA ACCOURD
The maintenance required light only goes on after 7,500 miles since last 'maintenance'. The maintence required light will not turn off by replacing or changing anything, the only way to turn it off is by putting your key in the key slot next to the light.
press the odo button and hold it. then turn the ignition to on - dont start the car. keep holding the odo botton for a few sec and it will clear.