0
Today is 8/13/10 (My Car:2004 Honda accord v6 manual Coupe) I just got my clutch master cylinder replaced, The part run roughly around $70 to $100. The labor fee varies, But everything together out the door cost me $230 that's including labor. Its really not that bad but for a student that needs to buy books and etc ITS SUPER BAD.
answers:
clutch master cylinder,the seal,and the fluid rubber tube,$114.00 hondapartsdeals.com all genuine Honda parts,another 90,000 miles for it
What else can I help you with?
How do i replace a clutch master cylinder in a 1996 Honda civic?
how difficult is it to replace the MS on a 1996 Honda accord
How do you convert a cable clutch to a hydraulic clutch in a Honda?
www.hasport.com has clutch master cylinder adapters. Here is the info from their page: "The new master cylinder adapter allows the use of a Honda-style or Wilwood clutch master cylinder to convert a cable transmission vehicle to a hydraulic setup."
If i replace slave cylinder will that make my clutch disengage and engage correctly?
if i replace slave cylinder in 1994 Honda civic ex will this make my clutch disengage and engage correctlyanswerchange master cylinder and slave properly then bleed the system properly.
How do you replace the clutch master cylinder and slave cylinder on a 2005 Honda civic si?
To replace the clutch master cylinder and slave cylinder on a 2005 Honda Civic Si, start by disconnecting the negative battery terminal and removing the clutch fluid reservoir cap. Then, detach the hydraulic lines from both the master and slave cylinders, taking care to catch any fluid. Next, unbolt and remove the master cylinder from the firewall and the slave cylinder from the transmission. Install the new cylinders in reverse order, ensuring all connections are secure, and then bleed the clutch system to remove any air.
Why does your clutch stick to the floor in a 92 Honda accord?
2 reasons: 1. There is no fluid in your master cylinder due to a leaking master cylinder or slave cylinder or 2. You blew your clutch
Where is Clutch Master Cylinder on a Honda Accord SE Year 2000?
its the brake resivior
Can you adjust a clutch on 1987 Honda shadow 1100?
If there is a hydraulic master cylinder at the clutch lever (looks like the front brake) then...NO.
How do you replace the master cylinder on a 1990 Honda CRX?
Hello,Here is a simple walk-through on replacing the master cylinder on a '90 CRX:Disconnect the negative battery cable and disable the SRS system (if equipped.) At the top of the clutch pedal, remove the cotter pin and pull the pedal pin out of the yoke.Remove the nuts and bolts holding the clutch master cylinder and remove the cylinder from the engine compartment.Disconnect and plug the hydraulic lines from the master cylinder.Installation is the reverse of the removal procedure. Bleed the clutch hydraulic system.
Where is the clutch hose on a 1989 Honda Prelude?
On a 1989 Honda Prelude, the clutch hose is typically located between the clutch master cylinder and the clutch slave cylinder. The master cylinder is mounted on the firewall in the engine bay, while the slave cylinder is located on the transmission. The hose runs along the chassis, connecting these two components to facilitate hydraulic fluid transfer for clutch operation. Always refer to a service manual for precise locations and diagrams.
How do you install a slave clutch cylinder for a 1994 Honda civic ex v-tech?
The slave clutch cylinder on a 1994 Honda Civic is located inside the engine compartment. On the driver-side close the firewall. The clutch fluid should be drained. Remove the mounting bolts and clutch lines to replace the slave clutch cylinder.
How do you fix a faulty master brake system on a 1995 Honda Accord?
If the Master Cylinder is defective then replace it.
My Honda having problems with the clutch it won't shift properly and I have tightened the cable. What should I do next?
figure out how to change master clutch cylinder and slave cylinder,then bleed the system properly
