it is under and behind wipers lift wipers away from window and remove don't worry will only go back right way on the gears. vented looking plastic that goes under wipers must be removed Phillips screws and popout plastic pins i broke mine you will be able to see complete wiper assembly with motor 3or 4bolts will remove entire wyper system i baught it all at junk yard 50.dollars not a hard job hope this helps
Underneath the wiper motor assy.
Broken linkage? Disconeccted linkage? EDIT::: The most likely cause is a bad wiper control module, its attached to the wiper motor
In many cars, there is only a single wiper motor. One wiper arm is attached directly to the wiper motor and the other through a linkage. If one is working, the motor is operating but the connection to the other may be broken.
It is usually locate on the firewall between the engine and the driving compartment. Read the owner's manual to understand where the wiper motor is located.
Look for a broken linkage going from the wiper motor to the wiper arms. Also check to see if the nuts holding the wiper arms are loose, that is one of the most common problems, but usually only affects one wiper arm at a time.
Your wiper motor is broken. Inside the motor a wire is burned that the wipers bring back in off mode. Just replace the wiper motor.
if its the driver wiper that doesn't work, its probably the control rod broken. the passengers wiper is driven by the motor, the drivers by the linkage from the passengers wiper mechanism
Broken or disconnected wiper transmission (linkage)?
: There is a pawl located in the wiper motor that tells the motor when to shut off and leave the wipers in the parked position. : if your wiper blades park in the vertical position, this pawl has broken off. : the motor more than likely needs replacing.
Remove the wiper arm from the wiper motor. Remove the wiring harness from the wiper motor. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.
Remove the wiring harness from the wiper motor. Remove the windshield wiper arm from the wiper motor. Remove the wiper motor retaining screws. Reverse the process to install the new wiper motor.
Wiper arm travel rod from the wiper motor. Remove the wiper motor wiring harness. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.