Thank the volunteer contributor at the following site. It's for a 1993 Camry, but probably applies to yours. I have a 1996 Camry and it explained how to remove the trim around the inside door handle, where I was stuck in my removal process. Good luck. http://autorepair.about.com/od/otherodddiyjobs/l/aa092504a.htm
To remove the door panel on 99 Toyota Camry LE, first unscrew the screws holding it to the door. These are on the inside of the car. Once the screws are removed, the panel will lift off.
To replace the door handle on a 2000 Toyota Camry, first, remove the door panel by unscrewing the screws and unclipping the plastic fasteners. Next, disconnect the door lock and handle linkage from the old handle. Remove the bolts securing the handle to the door, then replace it with the new handle by reversing the steps. Finally, reattach the door panel and ensure everything is secured properly.
Browse FAQ and find the answer to this question: In 2000 Camry power mirror replacement is it necessary to remove the door panel or is the connector wire long enough to pull the connector end up and any pitfalls in panel removal?
Go to this website. It will show how to remove the door panel.
You have to remove the door panel, after that you will be able to replace the speaker.
Search Browse FAQ's for the answer to this question: In 2000 Camry power mirror replacement is it necessary to remove the door panel or is the connector wire long enough to pull the connector end up and any pitfalls in panel removal?
To remove the door panel on a 1999 Toyota Camry, start by carefully prying off the plastic cover over the door handle using a flathead screwdriver to access the screws underneath. Next, remove the screws securing the panel, typically found near the handle and at the bottom of the door. Gently pull the panel away from the door frame, detaching any clips, and disconnect any electrical connectors if present. Once free, lift the panel upwards to remove it completely from the door.
There can be hundreds of reasons. You have to remove the door panel and the power door mechanism.
Magic
Remove the screw under the door latch
Using a screw driver, remove the screws and remove the clips from the door panel. Remove the panel slowly, remove any wire connections, and pull the panel off the door frame.
You will need to remove the screws in the door. They are located in the door handle, the door latch and at the very bottom of the panel. Once you remove the three screws pull the panel and it will pop out.