answersLogoWhite

0

From the AutomotiveForums link mentioned below:

Remove the plastic corner panel that's inside the trunk covering the back of the light assembly and reach in with your fingers and remove the bulb and socket. From the back it's easy to confuse whether you are removing the brake light, the backup light or the blinker light socket so it would help to have an assistant step on the brakes or turn on the parking lights etc. to make sure you've got the right bulb. Installation is the reverse of removal . . .

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you change rear brake pads on 2002 Toyota Corolla?

How do you replace the front break pads on a Toyota corolla .


How long does it normally take to replace brake lines on a 1995 Toyota Corolla?

It should only take about an hour to replace the brake lines on a 1995 Toyota Corolla. The exact time will depend on your experience with replacing brake lines.


Why does my 1996 Toyota Corolla start but will not go into gear. And I do not have brake lights eighter?

A brake light switch may be bad if a 1996 Toyota Corolla will not go into gear and the brake lights don't work. Another issue could be in the shift lock solenoid.


What makes brakes lights stay on 93 Toyota Corolla?

A malfunctioning brake light relay switch will cause your 1993 Toyota Corolla brake lights to stay on all the time. The brake light relay switch is located beneath the drivers side dashboard.


What causes brake lights of 1994 Toyota Corolla to remain on?

Defective or mis-adjusted brake light switch


Why don't brake lights turn off on an 89 Toyota Corolla?

Check the brake light switch located under the 1989 Toyota Corolla. If the switch is stuck the parking light will continue to stay on.


Where is the brake switch on a 1999 Toyota Corolla?

The brake switch on a 1999 Corolla should be on the top of the brake pedal arm. If the switch goes bad, then the brake lights might stay on, or not come on at all.


Where in the trunk is the controller for the brake lights located in a 1991 Toyota Corolla?

If by 'controller' you mean the switch that makes the brake lights come on, it is not in the trunk. It is located underneath the dashboard, next to the brake pedal.


Why don't brake lights work on a 1989 AWD stick shift Toyota Corolla wagon though regular tail and other lights work and all bulbs and fuses have been checked or replaced?

replace brake light switch on brake pedal if it hasn't been done try that


Where is the brake fluid filler located on a 2004 Toyota Corolla?

Where is the brake fluid filler located on a 2004 Toyota Corolla?


The charge and brake lights on 1986 Toyota pickup stay on?

Replace Alternator


How do I replace the Corolla 2006 brake light?

To replace the brake light on a 2006 Toyota Corolla, first, open the trunk and locate the tail light assembly. Remove the screws or clips holding the assembly in place, then gently pull it out. Twist the bulb socket counterclockwise to remove it, replace the old bulb with a new one, and reassemble by reversing the steps. Ensure the new bulb is securely in place before testing the brake lights.