I have a Mazda MPV v6 2000 model, right hand drive from Japan, I read a couple of webpages and started to remove all seats etc when I realised I could save hours another way
It is easier to get a very sharp stanley knife and cut an access flap in the undercarpet between the front seat and the second row seat, (where your feet are when you are sitting in the second row seat) THIS WILL SAVE HOURS OF REMOVING AND REPLACING SEATS ETC. and the flap will not be noticed as it is covered by the removable top carpet, If you need help, email me on raymunt@gmail.com.After doing that unscrew 4 screws to remove the cover, disconnect the 2 fuel lines by squeezing the retaining clip and pulling the pipes off, remove the electrical connection carefully by easing the retaining clip and pulling the connector off, clean all around the unit so dirt does not go into your tank, unscrew all the small screws and lift out the pump and filter unit. I takes longer to cut the carpet and underlay than remove the pump. To remove the tank, after the top unit is disconnected, remove the big filler rubber pipe and two small ones above it, unscrew 5 bolt and it drops out so easily. I siphoned my fuel out first through the filler pipe on the tank after removing the rubber pipe. it took me about two hours to clean out the tank and replace but next time it will take less than 30 minutes because of that access hole in the carpet. I have a few photos but do not know how to put them on this site
how to reset a fuel pump on a Mazda MPV van 2000
on an '01 Mazda MPV the fuel pump is on the left side of the vehicle. older MPVs have it on the right
How do you replace a fuel injector on a 2001 Mazda mp
Replace it when it's dirty.
Mounted on top and inside the fuel tank.
To replace the fuel pump in a Mazda MPV, first ensure the vehicle is off and disconnect the negative battery terminal. Drain the fuel tank and remove it by unbolting it from the vehicle, then disconnect the fuel lines and electrical connectors. Once the tank is removed, access the fuel pump by taking out the retaining ring on the top of the tank, replace the old pump with the new one, reassemble everything in reverse order, and finally reconnect the battery. Always check for leaks before starting the engine.
in the pump, which is in the tank.
inside the gas tank
What is the cost to replace the head gasket on a Mazda MPV?
The fuel pump is mounted on top and inside the fuel tank. The filter may be integrated into to fuel pump or it will be located between the fuel tank and the engine.
Fuel pump is in the gas tank,access from under the carpet behind the passenger seat
To replace the fuel filter on a 1991 Mazda MPV, first, ensure the vehicle is turned off and relieve fuel system pressure by removing the fuel pump fuse and starting the engine until it stalls. Next, locate the fuel filter, typically found along the fuel line under the vehicle or near the engine. Using appropriate tools, disconnect the fuel lines from the filter, being careful to catch any spilled fuel. Finally, install the new filter in the same orientation, reconnect the fuel lines, and replace the fuel pump fuse before starting the engine to check for leaks.