There is a procedure for re-setting the airbag light without special tools. Rather than trying to explain it here, just do a Google search. YouTube has videos showing the procedure too. Do not take your car to Honda to have impact sensors and airbag control units replaced just for this unless you determine that that is necessary. The original answer to this question incorrectly advised people to do that.
No it will not
no it does not
IT IS A WARNING LIGHT TO TELL YOU THAT A DOOR IS NOT SHUT PROPERLY
The light will shut itself off when the failure that the computer detected is repaired.
If the yellow light is a triangle with an exclamation point in it, it means you traction control is either working at that instant, or shut off. You probably just bumped the button which is located to the left of the steering wheel. Push it again and the light will shut off, and the system will again engage when it is supposed to.
The alarm box controls the shutdown of the vehicle when it gets too hot by using information from a temperature sensor. The CDI will shut down. It also controls the red warning light.
It means that there is some sort of maintenance required - you'd need to pull codes to determine exactly what. Performing the required maintenance successfully should shut the light off.
The airbag light stays on when the computer has detected a malfunction and set a code. The failure will need to be repaired before the light will shut off.
Owner's manual!
it means your motor is about too shut down and or is overheating.
Most makers recommend that IF you shut down a pilot light for the summer, you have the system inspected and serviced before restarting. The pilot light also serves to drive off moisture from your controls during summer, preventing corrosion. See what YOUR manufacturer suggests.
When pilot light goes out, gas flows out of the pilot light nozzle. If out has continued for a long time, a gas cloud can develop around the furnace. When you go to light the pilot light, you'll ignite this gas cloud and make a big fire ball. If your basement is drafty, you might never get a huge cloud of gas hovering around your furnace. When you notice that your pilot light is out, you should shut off the gas to the furnace and allow any stray gas to dissipate before you turn the gas back on and light the pilot light. alliedallcityinc.com