To install a stereo in a 1995 Lexus GS300, start by disconnecting the car battery to ensure safety. Remove the trim panel around the factory stereo using a trim removal tool, then unscrew the existing unit and disconnect the wiring harness and antenna. Connect the new stereo's wiring harness adapter to the car's wiring, secure it in place, and reattach the trim panel. Finally, reconnect the battery and test the new stereo to ensure proper functionality.
how do i reset the computer in gs300
To remove the radio check this link out. It gives instructions. www.installer.com/pdf/95-8152.pdf
To remove the driver and passenger seats from a 1995 Lexus GS300, first disconnect the negative battery terminal to prevent any electrical issues. Next, slide the seat all the way forward to access the rear bolts, and remove the bolts using a socket wrench. Then, slide the seat back to access the front bolts, remove them, and carefully lift the seat out of the vehicle, ensuring to disconnect any electrical connectors for power seats or airbags if applicable. Repeat the process for the other seat.
$41,139
Vehicle Stability Control
Yes it does :)
Red and Yellow
At intervals of 90,000 miles
Under the hood just below the Brake master cylinder
300,000 i own a 95 with 264000 and it runs great
The "Related Questions" below add up to a full tutorial / how-to on installing a radio into a Taurus / Sable.Be sure to focus on the one for removing a radio from the 1986-1995 Taurus/Sable - not the other one about a converter plate as it doesn't apply to your '95.
The stereo is wired wrong. In this case it sounds like the ground wire of the stereo is hooked to the dimmer circuit. The ground wire of the stereo should be connected to the vehicle chassis.