The ECT Senor is located on the passenger side of the engine, between the firewall and the back of the engine, on top of the engine. It's almost impossible to see and barely able to be touched by hand. I'm not sure how you're supposed to R&R it though. Ceck all your fuses first.
Yes, there is a diagram of the oxygen sensor location of a Isuzu Trooper. This diagram can be found in the cars maintenance manual.
The oxigen sensor can be found on the exhaust manifold or exhaust pipe
Coolant leaking from the heater core.
on the exhaust manifold.
how do you replace coolant temp sensor on a rodeo
The thermostat on a 2000 Isuzu Trooper is located on top of the engine, below the upper radiator hose. It controls the flow of coolant to the radiator and throughout the vehicle.
On a 2001 Isuzu Trooper, the knock sensor is typically located on the engine block, near the intake manifold. It is generally positioned on the driver's side, towards the rear of the engine. To access it, you may need to remove some components, as it can be somewhat hidden. Always refer to a service manual for precise location and guidance.
Drivers side behind the convertor.
Driver side
There should be a drain on the bottom of the radiator somewhere. If you cannot find one, then remove the lower radiator hose and drain the coolant form that location.
Isuzu Trooper was created in 1981.
Same location where you pour the motor oil