0
A 5-blink code on your 2006 Honda Rancher 350 ES typically indicates an issue with the shift motor or its wiring. Since you've replaced the angle sensor and confirmed the battery is fully charged with clean connectors, check the shift motor for proper operation and inspect the wiring for any damage or corrosion. Additionally, ensure that the neutral switch is functioning correctly, as it can also affect shifting. If issues persist, consider consulting a service manual for further troubleshooting or seeking professional assistance.
What else can I help you with?
2006 Honda rancher 350 ES wont shift. The battery is fully charged the angle sensor has been replaced and the connectors are clean. any ideals?
If your 2006 Honda Rancher 350 ES won't shift despite a fully charged battery and a replaced angle sensor, consider checking the shift motor and its connections for any issues. Additionally, inspect the wiring harness for damage or corrosion that might affect the shifting mechanism. It's also worth examining the shift linkage for any mechanical obstructions or misalignments. If the problem persists, a diagnostic scan may help identify any underlying electronic issues.
My 2005 Honda Forman rancher ATV dies unable to start or shift back to neutral when checking battery still says it is fully charged. Could it be a regulator problem?
My 2005 Honda Forman rancher ATV dies unable to start or shift back to neutral when checking battery still says it is fully charged. Could it be a regulator problem?
I turned off my Honda rancher. When I restarted it everything went dead. Could this be a fuse Is the box located behind the battery?
Try checkimg the main 30Amp fuse ,And then check that all the wire connectors are tight and not coroded.
How do you get a Honda rancher in neutral when battery is dead?
A Rancher ES Should have a lever in the storage compartment to manually shift gears with.
What type of battery is on Honda rancher ATV?
The Honda Rancher ATV typically uses a sealed lead-acid (SLA) battery, specifically a 12V battery. The exact model may vary depending on the year and specific model of the Rancher. It's important to check the owner's manual or specifications for the exact battery type and size required for maintenance or replacement.
Why is your gear indicator flashing on your Honda rancher es?
Low battery.
How do you recharge a 2006 Honda rancher ATV?
To recharge a 2006 Honda Rancher ATV, first, ensure the battery is in good condition and check the connections for any corrosion. Use a compatible battery charger, connecting the positive (red) clamp to the positive terminal and the negative (black) clamp to the negative terminal. Set the charger to the appropriate voltage for the battery, usually 12 volts, and allow it to charge until fully charged, typically indicated by the charger. After charging, reconnect the battery to the ATV and ensure all connections are secure before starting the engine.
How do you remove carburetor from 2006 Honda rancher?
To remove the carburetor from a 2006 Honda Rancher, start by disconnecting the negative battery cable for safety. Then, remove the air intake duct and throttle cable, followed by the fuel line and any electrical connectors attached to the carburetor. Finally, unbolt the carburetor from the intake manifold and carefully pull it free. Make sure to keep track of any gaskets or seals for reinstallation.
Where is battery located on 2008 Honda rancher 420 es?
the battery is behind the seat under the black cover you will also see the fuse box
What is the battery size for a 2002 Honda rancher?
The 2002 Honda Rancher typically uses a 12V battery with a size designation of YTX14-BS. This sealed, maintenance-free battery has a capacity of around 12 Ah. It's important to ensure that the battery is compatible with your specific model and any additional accessories you may have. Always consult the owner’s manual for the most accurate specifications.
What type of battery does a Honda rancher 350 use?
The Honda Rancher 350 typically uses a 12V, 12Ah sealed lead-acid battery, commonly referred to as a maintenance-free battery. It's important to check your specific model year and consult the owner's manual for the exact specifications, as variations may exist. Ensure proper battery maintenance for optimal performance and longevity.
Wiring diagram for battery on 2005 Honda rancher?
To wire the battery on a 2005 Honda Rancher, connect the positive (+) terminal of the battery to the positive cable, ensuring a tight fit. Then, connect the negative (-) terminal to the negative cable. Ensure both connections are secure and free of corrosion. Finally, route the cables neatly to avoid any interference with moving parts.
