yes
The 1989 Acura Legend transmission shift cable is held in place with swivel nuts. Loosen the swivel nuts on each end of the cable. The transmission shift cable will come out.
Common signs of a broken transmission shift cable include difficulty shifting gears, the gear indicator not matching the actual gear, and the vehicle not moving when the transmission is in gear. To repair a broken transmission shift cable, the cable will need to be replaced by a professional mechanic.
The shift cable for a 1998 Ford Expedition allows the transmission to be shifted throughout the available gears. It is linked directly from the shift lever to the side of the transmission.
The gears in your transmission may be sticking or worn out. This would cause your transmission to not be able to shift.
The transmission uses a cable for linkage. If the car has consol shift the cable runs from the shifter to the transaxle. If it is a column shift the cable runs from a lever on the column to the transaxle.
Shift cable has unhooked, fluid too low, transmission failed.Shift cable has unhooked, fluid too low, transmission failed.
Depending on the model they are usually located on the transmission. Just below the shift linkage and cable. Follow the shift cable to the transmission and you will find it. you will have to remove the shift cable and lever , then unbolt the switch and work it up off the shaft.
Look on the top of the transmission. The shift cable attaches to a "box" with a wire harness attached. That's it. Look on the top of the transmission. The shift cable attaches to a "box" with a wire harness attached. That's it. Look on the top of the transmission. The shift cable attaches to a "box" with a wire harness attached. That's it.
yes
The cable between the shift lever and the transmission may be bad.
If it's a stock transmission, the shift linkage is mechanical.
This is commonly cause when the transmission is replaced and the shift linkage is not hooked up properly. Find the shift cable on your transmission and disconnect it, then put your shifter into park. The transmission linkage needs to be put in park as well. Now that both the transmission and your shifter are in park, you can adjust the cable accordingly and reconnect it. This should solve your problem.