Haynes Auto Repair Manual say's
Clutch pressure plate-to-flywheel Torque should be 11 to 15 Ft-LBS
Hope that helps....
80Lbs for flywheel, 10 to 15lbs for pressure plate
Pressure plate to flywheel torque is (ft lbs) 14 to 20.
Pressure plate to flywheel torque is (ft lbs) 14 to 20.
The torque setting for the pressure plate on the clutch for an s10 2.2 is 33 foot pounds. The torque for the 4.3 is 29 foot pounds.
Pressure plate to flywheel bolts - 24 ft/lbs
pressure plate to flywheel bolts - 15 to 24
Just make the clutch pads line up with the clutch disk. the pressure plate can only go on one way due to the positioning dowels
The torque setting for the clutch on a Toyota Hilux typically ranges from 20 to 30 Nm for the pressure plate bolts, depending on the specific model and year. It's essential to consult the vehicle's service manual for the exact torque specifications, as they can vary. Always use a calibrated torque wrench to ensure proper installation and avoid damage.
55 ft lbs then 120 degrees 55 ft lbs then 120 degrees
For a 1991 Toyota Tercel, the torque specifications for the clutch plate mounting bolts are typically around 19-22 lb-ft (25-30 Nm). It's important to follow the proper sequence when tightening to ensure even pressure. Always consult a repair manual or the manufacturer's specifications for the most accurate information.
whats the torque spec for the pressure plate on a 1998 kia sportage?
What are the torque specs for a flywheel and pressure plate on a Datsun 240Z