answersLogoWhite

0

For Lexus RX300 - if you try to spray the wate and can't hear the motor/pump working, then most likely the pump is out of order. Need to order another pump.

1. Pull back the fender on the right hand side, right under the container (don't even have to open any nut)

2. You should find the pump attached to the container - just unplug the power source

3. Pull the pump out of the container (make sure to have a bucket to catch all the fluid) and unplug two pipes connected to it.

4. Install the new pump, and plug the power cable back in.

User Avatar

Wiki User

9y ago

What else can I help you with?

Related Questions

How to troubleshoot Lexus 2001 gs 300 windshield washer?

To troubleshoot the windshield washer on a 2001 Lexus GS 300, first check the washer fluid reservoir to ensure it is filled. Next, inspect the washer pump by listening for a noise when the washer switch is activated; if there's no sound, the pump may be faulty or there could be an electrical issue. Additionally, examine the washer nozzles for any blockages and clear them if necessary. If the pump and nozzles are functioning properly, consider checking the fuse related to the washer system.


What is the part underneath the windshield washer reservoir?

It could be the windscreen washer motor


Where is the windshield washer pump on 1995 Taurus?

It could on the bottom if the washer fluid reservoir - look there first.


What would cause low windshield washer spray after fender repair?

If you were in a wreck you could have damaged your washer fluid reservoir or hoses leading to the spray nozzles. Slightly fill your reservoir with water and observe for leaks.


How can you fill the rear windshield wiper reservoir of a Dodge Dakota?

A Dodge Dakota does not have a rear washer fluid reservoir. On most newer vehicles the washer fluid for the rear windshield comes from the washer fluid reservoir from under the hood. If you are not getting wahser fluid to the rear windshield it could be that the line is frozen or clogged with dirt or the line could be disconnected somewhere.


What would cause the windshield washer pump to barely work on a 1999 VW Jetta?

If Your Question Is That You Are Not Getting Much Water Onto The Windshield. Look For The Screen To Be Partially Stopped Up In The Washer Fluid Tank Or The Hose. Also You Could Have A Small Hole In The Line Not Allowing The Unit To Pull The Fluid To The Wipers.


Which fuse controls the windshield washer for a 2005 Dodge Durango?

Should be the same as the wipers--Check to see if you are getting power to the washer pump - if so could be a bad washer pump


If the windshield washer pump is working on a 94 civic but no fluid will spray on the windshield what could be the problem?

you may have a block in the line behind the pump stopping the fluid


Where do you find the battery you could not find it when you looked under the hood?

It appears to be under the windshield washer fluid tank


What causes my windshield wipers and washer in 1987 5th Avenue not to work?

could be blown fuse or short in wiring


Windshield washer indicator stays on Acura MDX?

If the windshield washer indicator stays on in an Acura MDX, it typically indicates that the washer fluid reservoir is low or empty. Check the fluid level and refill it if necessary. If the fluid level is adequate and the indicator remains illuminated, there may be a malfunction with the sensor or wiring, which could require further diagnosis by a professional.


What can cause the fluid pump For windshield washer to not work on a 2008 Chevy impala The wind shield wiper pump not working on a 2008 Chevy impala when full could be merely the fuse blown?

Several factors can cause the windshield washer pump on a 2008 Chevy Impala to not work, even if the reservoir is full. A blown fuse is a common issue, but other possibilities include a faulty pump motor, clogged washer fluid lines, or a malfunctioning switch. Additionally, wiring issues or poor connections can prevent the pump from receiving power. It's essential to check these components systematically to identify the root cause.