well pop your hood. you're going to need a 12mm socket to unbolt the battery post so then you can remove your battery. that's all. just make sure you remove the + and the - post so you can take out the battery.
a) car service center b) private car mechanic c) hammer d) shotgun e) locate the battery and remove it
To replace the alternator in a 1993 Toyota Previa LE, first disconnect the negative battery terminal to ensure safety. Remove any components obstructing access to the alternator, such as the air intake duct or electrical connections. Unbolt the alternator from its bracket, carefully disconnect the wiring harness, and then install the new alternator by reversing the removal steps. Finally, reconnect the battery terminal and check the tension on the drive belt before starting the engine.
Unless the actual arm is broken, I would just replace the rubber. You can order it from Toyota, and its way cheaper than a whole wipe arm.
Remove a battery connector. Remove the starter and put another in it's place.
To change the thermostat in a 1992 Toyota Previa, first, ensure the engine is cool and disconnect the negative battery cable. Drain the coolant, then locate the thermostat housing, which is typically near the engine block. Remove the housing by unscrewing the bolts, take out the old thermostat, and replace it with the new one, ensuring the rubber gasket is properly seated. Reassemble by reversing the steps, refill the coolant, and check for leaks.
first remove the battery cables from the battery, get under the car behind the pass side. follows the battery wire and will lead you to the starter remove tha hot wire and the ground wire off the starter remove two bolts that holds the starter and install the new one and reverse the presigues ...
How to remove battery cover to replace battery
pull out the battery or what ever is in front of it , or get a flash light and get your hands in there. it cant be that hard , you must atleast look at the back or call Toyota to see if it is poossible to remove the bulb and how to do it
remove the radiator, then remove 4 screws that holds the fan ,,done..
yes, you have. And change new seal too.
Remove the negative battery cable for 6 minutes and then replace.
I would advise you to check out the Previa site on yahoo. It is an excellent site. Check this site it out http://tarago.blogspot.com/ , it helped a lot.