answersLogoWhite

0

What else can I help you with?

Related Questions

What is the torque specification for the front axle nut on a Windstar?

Axle nut torque specs are 170-203 ft.lbs


What is the torque specification on a 2001 Toyota tundra front oxygen sensor?

The 2001 Toyota Tundra front oxygen sensor torque specification is 20 pounds. The oxygen sensor bolts should be torqued in 10 pound intervals.


What is the torque for a ford aerostar awd front hub?

The 2000 Ford Explorer front hub nut has a torque specification of 140 pounds of pressure. The hub should not be over tighten. Over tightening can ruin the seal.


What is the front brake caliper torque spec for cavalier?

The front brake caliper torque specification for a Chevrolet Cavalier typically ranges from 20 to 30 foot-pounds, depending on the specific model year and engine type. It's always best to check the vehicle's service manual for the exact torque specification applicable to your Cavalier. Proper torque is crucial to ensure safe and effective braking performance.


What is front axle shaft nut torque spec for 1998 GMC jimmy?

The 1998 GMC Jimmy front axle shaft torque specification is 60 pounds. You want to make sure that you do not over torque the axle shaft, as you can ruin the axle bearing.


Looking for torque spec for 2001 forester front drive axle nut?

The 2001 Forrester front drive axle nut torque specification is 90 pounds. The front drive axle nut should be torqued in 45 pound intervals.


What is the front axle nut torque on a 2004 Chevrolet trailblazer?

The front axle nut torque specification for a 2004 Chevrolet Trailblazer is typically around 150-175 ft-lbs. It's important to use a torque wrench to ensure the nut is tightened to the correct specification for optimal performance and safety. Always refer to the vehicle's service manual for the most accurate information.


What is the torque specification for the front axle nut on a 2007 torrent?

The torque specification for the front axle nut on a 2007 Pontiac Torrent is typically around 150 ft-lbs (or 203 Nm). It’s essential to follow the manufacturer’s guidelines and use a torque wrench to ensure proper installation. Always refer to the vehicle's service manual for the most accurate and specific information.


What is the foot pound torque for front brake rotors on a 1978 VW Bus?

Consult a generic torque specification chart based on the size and grade of the of the bolts (top of bolt will have that info on it).


What is the torque spec for a front wheel hub nut on a 2009 Dodge Avenger?

The torque specification for the front wheel hub nut on a 2009 Dodge Avenger is typically around 150 ft-lbs. It's important to ensure that you use a calibrated torque wrench to achieve the correct specification for proper installation and safety. Always refer to the vehicle's service manual for the most accurate and detailed information.


How do you take off rack and pinion on 05 tacoma?

To remove the rack and pinion from a 2005 Toyota Tacoma, first, lift the vehicle and secure it on jack stands. Disconnect the battery, then remove the front wheels, and drain the power steering fluid. Unbolt the steering column from the rack, detach the tie rod ends, and remove any brackets or lines connected to the rack. Finally, unbolt the rack and pinion from its mounting points and carefully remove it from the vehicle.


How do you repair front brake cylinder front Toyota tacoma 1995?

the tacoma has calipers on front.