Ticking lifters in the 86-93 Mazda pickup trucks is very common, the design is just prone to it. Sometimes it is dirt or something clogging one of the small passageways in the rocker arm assembly, sometimes it is low oil pressure, sometimes it is just a bad lifter. Sometimes replacing the lifter will fix the problem other times it won't.
It is often recommended to remove the entire rocker arm assembly clean it well, run a needle or wire through the find passageways, replace any damage hydraulic lash adjusters then reinstall. See the attached link for more details.
K6
Mazdatruckin.com
Stuck hydraulic lifter.
Saturn vue V6 lifter noise when first started
NO. The engine computer is in open loop until the engine heats up to operating temperature 195 degrees are more. that means it don't hear the lifter noise and by the time the computer can, the lifter quites making noise.
Collapsed hydraulic valve lifter? Rocker arm (valves) need adjusting?
To fix a noisy lifter in a 2000 Mazda B3000, start by checking and changing the engine oil and filter, as low or dirty oil can cause lifter noise. If the noise persists, consider using an oil additive designed to clean and lubricate lifters. If the issue continues, you may need to inspect the lifters for wear or damage, which could require disassembling the engine to replace them. Always consult a repair manual or a professional mechanic for specific guidance tailored to your vehicle.
To stop engine lifter noise, first ensure that the engine oil is at the correct level and is of good quality, as low or dirty oil can cause lifter issues. If the noise persists, consider using an oil additive designed to clean and reduce lifter noise. If the problem continues, it may indicate worn lifters or other internal engine issues, necessitating a professional inspection and possible replacement of the lifters. Regular maintenance and oil changes can help prevent such problems in the future.
Depending on the vehicle, it most likely needs adjustment.
New lifters or repairing the cause of low oil pressure.
Bearing noise is usually deeper and comes from farther down in the engine. Lifter noise is more of a ticking and is up in the engine heads.
An air intake house can be the cause of wind noise underneath a 208 Mazda 6. The problem could also be a bad seal on either your window or door gasket.
Is it a lifter ticking?
could be a lifter sticking