0
What else can I help you with?
Where is the intake air temperature sensor located on a 2005 Subaru wrx?
The intake air temperature sensor on a 2005 Subaru WRX is part of the mass air flow sensor. It is located in the air intake duct.
Where is the knock sensor location on a 1998 subaru legacy?
In a 1998 Subaru Legacy, the knock sensor is located on the top of the engine block and to the left of the engine. More specifically, it is under the left rear intake manifold runner.
Where is the engine coolant temperature sensor located on a 2012 subaru legacy 2.5i?
On a 2012 Subaru Legacy 2.5i, the engine coolant temperature sensor is typically located near the thermostat housing, which is situated on the engine's front, near the intake manifold. It is usually attached to the cylinder head or engine block. To access it, you may need to remove some components, such as the air intake duct or other nearby parts, for better visibility and access.
Where is the knock sensor on a 1997 subaru legacy gt 2.2 liter?
It is threaded into the block, under the intake manifold.
Where is the intake air temperature sensor located on a 99 subaru impreza 2.0 liter?
The IAT, intake air temperature sensor, measure the temperature of the outside air as it hit the air duct. ?æWhen you look under the hood and follow the intake air hose you will find the sensor.
Where is the IAT sensor on a 1995 Subaru Legacy?
The IAT is located in the air intake duct. First, find the intake air hose, and then follow that to the sensor, which should be located with the mass air flow sensor if it is double?æoverhead cam engine.
Where is the map sensor on a 1996 Subaru legacy?
It is located to the right of the ignition coil pack, on top of the motor. It is the black sensor, right behind the alternator, bolted into the intake manifold.
Where the coolant temperature sensor located in 1996 subaru legacy outback?
http://www.lovehorsepower.com/SubaruDocs/CoolantTempSensor.htmlits a 1995 but same thing
Where is the knock sensor located on a 1996 Subaru Legacy 25?
It is underneath the intake manifold. If you look straight down from your throttle body, you will see a sensor with one wire coming out and a bolt going through the middle of it, that is the knock sensor.
Where is the knock sensor on a 98 subaru legacy outback?
Looking at the top of the motor remove the air intake and it is below the butterfly on the drivers side top end of the motor.
How many wires on a after cat O2 sensor subaru legacy?
four4
How do you change the knock sensor on a 1998 Subaru Legacy Outback?
Its on top of the engine by the fuel injection (remove the air intake first). Need a 10mm socket with a long extention.
