Brake fluid location in 1992 Mazda mpv
The brake fluid in a 1992 Ford Escort gets put in the brake fluid reservoir. This is normally located on the master cylinder.
To refill the brake fluid for a 1992 Acura, you need to remove the cap on the brake fluid reservoir. Add fluid until the dipstick measures full, or the line on the reservoir that says 'full' is touched by the brake fluid.
The clutch master cylinder is supplied from the brake fluid reservoir via a rubber tube.
Just in front of the driver's position inside the engine compartment is a big round thing, with a fluid reservoir on top. This is the master cylinder for the brakes, and the reservoir is for the brake fluid.
To add brake fluid to a 1992 Toyota Townace, locate the brake fluid reservoir under the hood, typically near the back of the engine bay on the driver's side. The reservoir is usually a translucent plastic container with a cap labeled "Brake Fluid." Ensure the vehicle is on a level surface, then remove the cap and add the appropriate brake fluid type (usually DOT 3 or DOT 4) until it reaches the recommended level marked on the side of the reservoir. Always check for leaks and ensure the cap is securely replaced after adding fluid.
The clutch and brake cylinder share a common fluid reservoir.
If you mean where to add brake fluid, it would be in the brake master cylinder, usually located on the driver's side, near the firewall. You should be able to see a round plastic reservoir with a gray cap ... unscrew to add brake fluid.
Start with checking the brake fluid level in the master cylinder reservoir. If it is low for whatever reason, those lights will come on.
The relay you are looking for should be left of the brake fluid reservoir on the firewall, drivers side.
nxt to the brake reservior
DOT 3 brake fluid