In a Mazda 3, the clutch reservoir is typically located near the back of the engine bay, on the driver's side, close to the firewall. It is usually a small translucent plastic container with a cap labeled for clutch fluid. To access it, you may need to remove any engine covers or components obstructing your view. Always ensure the vehicle is parked on a level surface when checking or filling the reservoir.
On the firewall drivers side. Clutch runs from the brake reservoir
We have just had some probems with our Mazda E2000 Campervan, and needed to fill the clutch fluid. While we had some difficulty finding the reservoir, there is a reservoir near the steering wheel on the left. It says that it is for brake fluid, but it is also for the clutch. We bled the clutch and while bleeding it the reservoir where the brake fluid is store dropped confirming that this is also the clutch reservoir. Hope this helps.
it uses the "extra" fluid from the brake reservoir, so just check that you are ok on brake fluid and your clutch should be fine
The clutch hydraulic fluid reservoir for a Mazda 121 is located next to the brake booster and brake master cylinder. The reservoir is small and round and is close to the driver side fender.
1. Clutch fluid is brake fluid. 2. The fluid used for your clutch master/slave cylinders is pulled from your brake fluid reservoir.
look on the drivers side firewall
1st open your engine hood , on the drivers side on the firewall next to the hood hinge you will see a round cylinder with a black cap on it this is your clutch reservoir.
If it's a 1970cc Station Wagon it's next to the brake fluid reservoir on the bulkhead. The rectangular one is the brakes, the cylinrical one is clutch.
The clutch uses DOT 3 or 4 brake fluid, and shares the reservoir with the brake system. The brake fluid reservoir is the same as the clutch fluid reservoir.
clutch fluid. Small reservoir looking like the brake overflow reservoir only about 1/3 the size.
it has a cable. will not have a clutch reservoir
The clutch master cylinder on a 2007 Mazda 3 is located in the engine bay, on the driver's side near the firewall. It's typically mounted directly to the firewall and connected to the clutch pedal inside the cabin.