0
What else can I help you with?
How do you turn off the seatbelt sensor in your 2006 Toyota Corolla?
The sensor is located in the seat. The problem is that if you unplug the sensor the vehicle will not start.
How is engine affected if crankshaft sensor is dead?
If the crankshaft sensor is dead the engine will not start
Where is the engine oil sensor on a 1997 Pontiac sunfire 2.4l?
I believe it is located on the right side of the engine. (looking at it from front) there is a sensor right in the mid left side. I think it may be there because that same sensor is leaking oil from it when I start it..
Your Chevy s10 wont start it turns over but doesn't fire you just a snow storm and it is all gone now what is wrong?
Check the Chevy S10s crankshaft position sensor. The sensor is located low on the engine, and the snow could have gotten the connection damp. The engine will not start when the sensor does not operate.
How do you know when a crank sensor is bad in a 1988 Mazda 626 and how do you replace it?
Generally when the crank sensor goes out the engine will not start. The sensor on almost all vehicles is located in the front on the engine near the belts.In most cases it is held in place by a bolt.Usually they can be hard to get to.
What might be causing a loud rumbling vibration near the engine when you start up a 1996 Toyota Corolla especially when the sound is worse in the cold?
bad engine mout....i had same on a 1994 corolla
Are there sensors that would cause a 1997 dodge stratus to not start?
Yes, just about any sensor on the engine could cause a no start.Yes, just about any sensor on the engine could cause a no start.
97 Lincoln mark viii engine turns over but will not start?
Check Crank sensor located in the block near the ac compressor
Code for PO137 Bank 1 sensor 2 Where is this sensor located?
The sensor is left bank 1/1 is ft and 1/2 is the rear NEW ANSWER: Bank 1 is the drivers side of the engine. Sensor 2 will be the second sensor in the exhaust pipe on that side of the engine. Start were the exhaust pipe bolts to the engine and work your way down the pipe until you see the second sensor and that will be the 1 you need.
Why would a geo prizm not have spark engine Turns but does not start replaced entire distributor 3 times already all components are located inside arent they Crankshaft position sensor?
the cam position sensor and ignition coil are inside the distributor. the crank position sensor is located on the bottom front of the engine, behind the belts on the left side.
Will an engine start without the map sensor connected?
No
Is there a cold start sensor on 78 Seville or is it the same as the oxygen sensor?
Yes it does have a cold start sensor. It is located on top of a throttle body.
