0
Acura actually doesnt have an OBDII connector. Acura uses a silver box underneath the carpet where the passengers feet would be. Remove the carpet or pull it back some to reveal it and it will flash your code. I.E. flash pause flash flash flash flash means it has stored error code 1 and 4
What else can I help you with?
How can you change windshield wipers on a 1997 Acura Integra?
The 1997 Acura Integra has hook-end wiper arms. See the Sources and Related Links section below for wiper blade installation videos and correct attachment/length wiper blade sizes. Also, if you purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through. Very simple.
Where to hook up OBD2 scanner on 1998 integra?
The OBD2 connection port is located underneath the right side of the glove box in the passenger side foot well. It's a bright green connector.
On a 1993 Acura integra 1.8 DOHC non vtec you are not getting power to the fuel pump the relay is kicking on and off and the fuel pump is working when you hook it up to a power source?
change your main relay
Where is the diagnostics obd2 hook up on a 1995 Dodge Ram pickup half ton?
A 1995 Dodge Ram is OBD one, not two. The connector is a different shape and is under the hood.
How do you replace a starter on a 1995 Acura Integra?
I've changed it on 94 integra 4 door 3 times, im about to change it on a 95 2 door and it has a tighter compartment. their are 3 screws holding it in 1 on top and 2 deep under the unit itself its best to use extensions to hook up to it after removing radiator hoses and other wires out of the way. will keep ya posted. if you find this too difficult just take it to a mechanic. lol
Where is the connector located for an Actron Code Scanner on a 1995 Mercury Villager?
Unless you have the CP9190 model which includes several different hook-up cables, it can not be done. Pre-1996 vehicles are equipped with the OBD I system. The connector on the 1995 Villager is located on the transaxle near the starter.
Where to hook up obd2 scanner on 98 integra?
Under passenger side. Far right
Where do you hook up a scanner to the ecu on a 1991 integra?
passenger side next to center console
How do you replace the ignition coil in 1991 Acura Integra and where is it?
The ignition coil is located under the distributor cap. There are a couple screws holing it in and a couple of wires. Just make sure the battery is diconnected first. Make sure you hook it back up the same way.
Where do you hook up a obdll scanner?
The OBD II DLC (data link connector) in most vehicles (1995, 1996 and up) is located just under the dash on the drivers side.
When was No Hook created?
No Hook was created on 1995-02-06.
Can you hook up a monitor to the parallel connector?
Yes if it is a old monitor.
