The knock sensor on a Hyundai Santa Fe Limited is typically located on the engine block, often near the cylinders. For most models, it can be found on the passenger side of the engine, secured by a bolt. Always refer to the vehicle's service manual for the exact location, as it may vary slightly depending on the engine type and model year.
Bank 2 Sensor 2 PO160 on a 03 Hyundai Santa Fe
where is located the crankshaft sensor in a Santa Fe 2001 2.7
abajo.
In the valley under inlet manifold
The oxygen sensor location for a Hyundai Santa Fe bank 1 sensor 2 the radiator and A/C line-Ox sensor body. The replacement sensors is available at most auto parts stores.
The fuel sensor on a Hyundai Santa Fe is located in the fuel tank. The fuel tank will need to be removed. The fuel sensor is attached to the fuel line. Remove the fuel line. The sensor can then be removed. Reverse the process to install the new sensor.
Check
Output speed sensor
if you buy it at korea. it is $12.
looking for a diagram to remove and replace a crankshaft sensor for a 2004 Santa Fe 2.4 cyl.
There is not a single ECU sensor. There are dozens of sensors on this car that feed the ECU
Vehicle speed sensor range/performance