The neutral safety switch on a 2000 Honda Rancher is typically located near the engine, mounted on the right side, where the gear shift linkage connects. It is situated above the left crankcase and is accessible from the side of the ATV. To locate it, you may need to remove the plastic side cover for better access. This switch ensures that the engine can only start when the vehicle is in neutral or park.
the switch is inside the back cover, but you should check the shift drum. the end of the shift drum has a slot in which the neutral switch sets in, and on my rancher the end of the shift drum was broke so when the quad is in neutral the switch said it was in gear you pretty much have to completely disassemble the whole engine and tranny to change the shift drum. good luck
no
how do i check the timing on my 02 honda 350 atv
My 2005 Honda Forman rancher ATV dies unable to start or shift back to neutral when checking battery still says it is fully charged. Could it be a regulator problem?
by touching your butt
The same place you check it at.
yes. I have a 08 rancher that is only 4 months old and the camo is coming off.
To put a 2011 Honda Rancher 420 in reverse, first ensure the ATV is at a complete stop. Then, locate the reverse override switch, typically found on the left handlebar; press and hold it. While holding the switch, shift the gear lever to the reverse position, which is often marked with an "R." Release the switch, and you are now in reverse.
Always use 10w40 ATV oil
0.8 to 0.9 mm
It should be designed for motorcycle or ATV wet clutches.