answersLogoWhite

0

The plug hole is near the right belt tensioner just to the outside along the edge of the engine block where the crankshaft position sensor electrical wiring enter the front casing or near where the a/c belt pulley bolts up to the engine block.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Where is the plug hole to check the balance shaft on 2003 Mitsubishi Galant?

I came across the same question myself. The plug hole is on the radiator side of the engine behind the exhaust. Mine was a size 14 mm bolt.


Where is the speed sensor for 2004 Mitsubishi Galant?

the speed sensor for 2004 Mitsubishi Galant is located on the front case of the transmission output shaft and speed sensor. It is approximately under the hood to the left of the engine.


What does the balance shaft do on a 1999 Mitsubishi Eclipse GST?

It balances the vibrations from the pistons...


Cost of replacing a1995 Mitsubishi galant front crank shaft?

The average cost to replace a 1995 Mitsubishi crankshaft is approximately $2000. The cost is dependent upon the mechanic shop's hourly rate.


Timing chain diagram for a 1986 Mitsubishi 2.0 liter?

It has a belt, not a chain...also has a balance shaft belt


How many drive belts are on a 2000 Mitsubishi galant 4-cylinder?

timing belt1 silent shaft belt2(behind the timing belt) accesory belt alternator3 powersteering a/c4


Why is your Mitsubishi vibrating?

Can be tire out of balance, bent wheel, defective tire, broken motor mount, or bent drive shaft.


How do you put a balance shaft belt on a Mitsubishi mighty max?

To install the balance shaft belt on a Mitsubishi Mighty Max, first ensure the engine is at top dead center (TDC) on the compression stroke for cylinder one. Remove any components obstructing access to the balance shaft assembly, then carefully align the balance shaft pulleys with the timing marks. Place the new belt over the pulleys, ensuring proper tension and alignment, then reassemble any removed parts. Finally, rotate the engine by hand to confirm that everything is aligned correctly before starting the engine.


Why would a 1988 Mitsubishi Galant 1800 suddenly lose all drive?

Reguardless where it is, the transmission will have to be overhauled. I think probably a shaft snapped or the bolts could have come out of the convertor if it was making noise before it happened.


Where is the speed sensor located on a 2003 mitsubishi galant ES?

On a 2003 Mitsubishi Galant ES, the speed sensor is typically located on the transmission. Specifically, it can be found on the side of the transmission case, usually near the output shaft. To access it, you may need to lift the vehicle and remove any protective covers or shields. Always consult the vehicle's service manual for detailed instructions and safety precautions.


Where the speed sensor is located in a Mitsubishi 2002 galant?

In a 2002 Mitsubishi Galant, the speed sensor is typically located on the transmission housing. Specifically, it can usually be found on the driver's side of the transmission, near the output shaft. This sensor monitors the speed of the vehicle and sends that information to the engine control unit (ECU) and the speedometer. If you have trouble locating it, consulting the vehicle's service manual can provide more precise guidance.


How much is a timimg belt for 2000 galant 4-cylinder?

theres 2,balance shaft and timing belt.mine were $75 for both,i installed them.@ a shop if you can get it done for under $500 your getting a good deal